ملخص المحتوى في الصفحة رقم 1
Over The Range
Over The Range
Installation Instructions
Contents
Important Safety Information ............................... 2
Parts, Tools, Materials ......................................... 6
STEP 1: Prepare The Electrical Connection ....... 8
STEP 2: Prepare The Venting System ................ 9
STEP 3: Prepare The Venting Blower .................11
STEP 4: Prepare The Wall & Upper Cabinet
For Installation ......................................13
STEP 5: Install The Mounting Plate ..
ملخص المحتوى في الصفحة رقم 2
IMPORTANT SAFETY INFORMATION PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY A. DO NOT attempt to operate this oven with the C. DO NOT operate oven if it is damaged. It is door open since open-door operation can result particularly important that oven door close in harmful exposure to microwave energy. It is properly and that there is no damage to the: important not to defeat or tamper with safety 1. Door (bent). interlocks. 2. Hinges and latches (broken or loosened).
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INFORMATION Recognize this symbol as a SAFETY message WARNING When using electrical equipment, basic safety precautions should be followed to reduce the risk of burns, electrical shock, fire, or injury to persons. 1. READ all instructions before using equipment. Contact nearest authorized service facility for examination, repair, or adjustment. 2. READ AND FOLLOW the specific "PRECAUTIONS TO AVOID POSSIBLE 10. DO NOT cover or block filter or other openings on EXPOSURE TO EXCESSI
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFETY INFORMATION FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT ( U.S.A. ONLY) This equipment generates and uses ISM frequency Reorient the receiving antenna of the radio or energy and if not installed and used properly, that is in television. strict accordance with the manufacturer’s instructions, Relocate the Microwave Oven with respect to the may cause interference to radio and television receiver. reception. It has been type tested and found to Mov
ملخص المحتوى في الصفحة رقم 5
IMPORTANT SAFETY INFORMATION Make Sure You Have Enough Space And Support WARNING Mount the oven against a flat, vertical wall, so it is To avoid risk of personal injury, install microwave oven supported by the wall. The wall should be constructed only as instructed. of minimum 2" x 4" wood studding and 3/8" thick drywall or plaster/lath. ATTACH AT LEAST ONE of the two lag screws supporting the oven to a vertical, 2" x 4" wall stud. WARNING DO NOT mount the microwave oven to an island or To
ملخص المحتوى في الصفحة رقم 6
Parts, Tools, Materials THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN: NOTE: Depending on your ventilation requirements, you may not use all of these parts. Damper/duct connector One power cord clamp and (for roof venting or wall venting installation) One dark-colored mounting screw Not Actual Size (2 pieces must be assembled as (to hold the power cord) shown) Actual Size One power cord clamp bushing - Actual Size (for the cord hole in a metal upper cabinet) Four 1/4" x 3" toggle bolts - Actual
ملخص المحتوى في الصفحة رقم 7
Parts, Tools, Materials You will need the following tools and materials for the installation: Carton or other heavy material for covering the counter top. Clear Tape Stud Finder or Thin Nail (for taping the templates to the wall) Keyhole Saw (for the power cord hole) Saber Saw (for cutting vent holes for roof or wall vending) Electric Drill Phillips Screwdriver (for the screws) 3/8" and 3/4" wood drill bits 1/2" and 3/16" drill bits Pencil Plumb Line Flat Blade Screwdriver (for the toggle bo
ملخص المحتوى في الصفحة رقم 8
STEP 1: Prepare The Electrical Connection W ARNING AVOID ELECTRICAL SHOCK! THIS APPLIANCE MUST BE GROUNDED! 1. Locate the grounded electric outlet for this oven in the cabinet above the oven, as shown in Figure 4. Upper NOTE: The outlet should be on a circuit dedicated to the Cabinet microwave oven (120V, 60 Hz., AC only) with a 15 or 20A fused electrical supply. IMPORTANT: If you do not have the proper wall outlet, you MUST have one installed by a qualified electrician. Grounded Outlet 2. You w
ملخص المحتوى في الصفحة رقم 9
STEP 2: Prepare The Venting System NOTE: The ductwork you need for outside ventilation is not included with your oven. The standard ductwork fittings and length are shown in Figure 9, page 10. WARNING-FIRE HAZARD THIS OVEN MUST BE PROPERLY VENTED! You may vent your oven in one of three ways. However, do NOT vent into a wall cavity, an attic, or an unused area. Roof-venting If your oven is located on an outside wall near the roof, as in Figures 6 (3 1/4" x 10" duct) and Figure 8 (6" round duct.)
ملخص المحتوى في الصفحة رقم 10
STEP 2: Prepare The Venting System Standard Fittings NOTE: If the existing duct is round, you must use a rectangular-to-round adapter, with a rectangular 3" extension duct installed between the damper assembly and the adapter to prevent the exhaust damper’s sticking. Duct Length The total length of the duct system, including straight duct, elbows, transitions, and wall or roof caps must not exceed the equivalent of 140 feet. For best performance, do not use more than three 90 degree elbows, and
ملخص المحتوى في الصفحة رقم 11
STEP 3: Prepare The Venting Blower W ARNING To avoid risk of property damage, unplug the microwave oven or disconnect power at source by removing fuse or throwing circuit breaker. To avoid risk of personal injury, wear protective gloves when handling mounting plate. DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in electrical shock. Your microwave oven is shipped with the blower assembled for room venting. If you want wall-venting or roof-vented
ملخص المحتوى في الصفحة رقم 12
STEP 3: Prepare The Venting Blower 4. Reassemble the blower wire. See Figure 14. 5. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 16. When you insert blower unit, blower wire must be like figure 15. 6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet. See Figure 16. 7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned. Attach with one blower unit mounting screw
ملخص المحتوى في الصفحة رقم 13
STEP 4: Prepare The Wall & Upper Cabinet W A R N I N G To avoid personal injury or property damage, do not attempt to install this microwave oven if you cannot find a wall stud. Measure And Track/Tape Up The Templates 1. Using a plumb line and (metal) measuring tape, find and mark the vertical center line on the back wall, as in Figure 23. 2. Find and mark one or two points where the studs are on the wall. (Studs are normally 16 inches apart). Then measure and mark the stud locations. If you can
ملخص المحتوى في الصفحة رقم 14
STEP 4: Prepare The Wall & Upper Cabinet W A R N I N G To avoid risk of personal injury, electrical shock or death: Note where electrical outlets and electrical wires are before you drill into the wall. Locate and disconnect power to any electrical circuits that could be affected by installing this oven. W A R N I N G To avoid risk of personal injury, electrical shock or death, cover the edge of the power supply cord hole with the power supply cord bushing. Drill The Holes In The Wall And Upper
ملخص المحتوى في الصفحة رقم 15
STEP 5: Install The Mounting Plate The Oven Must Be Connected To At Least One 3/16 Hole on Studs 5/8 Hole on Dry wall Only Wall Stud. Minimum 66" From the Floor 1. Draw a vertical line on the wall at the center of the 30 wide For Wall- space. Use the mounting plate as the template for the rear Vented Only wall. Place the mounting plate on the wall, making sure that the tabs are against the bottom of the cabinet. Line up the notch and center line on the mounting plate to the center line on the wa
ملخص المحتوى في الصفحة رقم 16
STEP 5: Install The Mounting Plate For Wall-Vented Make the box cutout for the rear wall duct. – 1 piece mounting plate: Us ing a pencil, put dots through slots F and G, and through holes H and I. Remove the mounting plate and draw lines extending through the points. This will give the location and size of the box cutout for the rear wall duct. (Figure 29) – 3 pieces mounting plate: Use the wall template to determine the location and size of the box cutout for the rear wall duct. Attach the exh
ملخص المحتوى في الصفحة رقم 17
STEP 6: Attach The Oven To The Wall W A R N I N G To avoid risk of personal injury or property damage, you will need two people to install this microwave oven. 1. Carefully lift microwave oven and hang it on support tabs (See Figure 27) at the bottom of the mounting power cord plate.Reaching through upper cabinet, thread power supply cord through the power supply cord hole in the bottom of the upper cabinet. See Figure 31. power cord hole 2. Rotate the microwave oven upward so the top of ove
ملخص المحتوى في الصفحة رقم 18
STEP 6: Attach The Oven To The Wall 5. Roof venting installation: See Figure 33. Install ductwork through the vent opening in the upper cabinet. Complete the venting system through the roof according to the method needed. See "Prepare The Venting System" STEP 2. Use caulking gun to seal the exterior roof opening around the exhaust cap. See Figure 6 on page 9. 6. Use the power supply cord clamp to bundle the power supply cord. Install the power supply cord clamp, using a Figure 33 screw as sho
ملخص المحتوى في الصفحة رقم 19
Sobre la estufa Sobre la estufa Instrucciones de instalación Contenido Información importante de seguridad ................ 20 Piezas, herramientas, materiales ....................... 24 PASO 1: Preparación de la conexióne eléctrica . 26 PASO 2: Preparación del sistema de ventilación 27 PASO 3: Preparación del ventilador.................... 29 PASO 4: Preparación de los gabinetes de pared y superior parainstalación ....................... 31 PASO 5: Instalación de la placa de montaje ...... 33 P
ملخص المحتوى في الصفحة رقم 20
INFORMACIÓN IMPORTANTE DE SEGURIDAD PRECAUCIONES PARA EVITAR LA EXPOSICIÓN POSIBLE A UN EXCESO DE ENERGIA DE MICROONDAS A. NO trate de operar este horno con la puerta abierta C. NO opere el horno si está dañado. Es ya que el funcionamiento con la puerta abierta puede particularmente importante que la puerta del horno causar la exposición excesiva a la energía de cierre adecuadamente y que no haya daños en: microondas. Es importante no desactivar ni alterar 1. La puerta (doblada). los seguros de
