GE JV356 30 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Use and Care & Installation Guide
Convertible Range Hood
Models: JV356 30†
JV656 36†
IMPORTANT SAFETY INSTRUCTIONS
Read and save these instructions.
WARNING—TO REDUCE THE RISK OF FIRE, E. Always use cookware and utensils appropriate for the
ELECTRIC SHOCK, OR INJURY TO PERSONS, type and amount of food being prepared.
OBSERVE THE FOLLOWING:
• When flaming foods under the hood, turn the fan on.
A. Use this unit only in the manner intended by the
WARNING—TO REDUCE THE RISK OF INJURY
manufacturer. I

ملخص المحتوى في الصفحة رقم 2

WARNING: Disconnect power before servicing or cleaning the unit. Care of Filter Care of Exterior Surfaces Charcoal Filter Pads (not included) For greatest efficiency the aluminum Use a mild detergent to clean the hood. This filter should be inspected filter should be cleaned periodically. DO NOT use abrasive cleansers. periodically and, when it becomes To remove the filter, pull the tab to saturated, it should be replaced. There Lights the side and then down. Soak it in hot are no effective mean

ملخص المحتوى في الصفحة رقم 3

4. Use the hood as a template. Mark the HORIZONTAL VENTING locations on the cabinet or wall for ductwork, (If the wall cap has a damper, do not install the electrical wiring and keyhole screw slots. damper blade on the hood.) Cut holes at marked locations for duct and Attach the damper with the small sheet metal electrical wiring. For the vertical duct, cut out 3/4† screws (#8 x 1/4† ). extra toward the front of the cabinet for movement of the duct when installing the hood. Check the damper for

ملخص المحتوى في الصفحة رقم 4

INSTALLATION INSTRUCTIONS Ductwork Requirements Ducting Chart The hood is shipped from the factory in the non- Equivalent Length in Feet 1 vented position. Use 3 ⁄4 x 10† or 7† round ducting for best performance. 7† RND Ductwork should be as straight as possible to the outside. Be sure to minimize openings through 1 3 ⁄4 x 10† outside walls or ceilings. These will have to be sealed later. The length of ductwork and number of elbows should 1 3 ⁄4 x 10† Transition to 7† : Round = 2 ft. be kep