AKG Acoustics SPC 4 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

IVM 4
SPC 4 - ESSENTIALS
© AKG Acoustics 2008

ملخص المحتوى في الصفحة رقم 2

SPC 4: SETUP Headline Single SPC 4 Setup: The SPC 4 works ONLY with AKG antennas SRA2W or RA4000W Power the SPC 4 Power all connected SST 4 NOTE: AKG recommends to use one SPC 4 / one antenna per 4 channels SST 4 !

ملخص المحتوى في الصفحة رقم 3

SPC 4: SETUP Headline Cascaded SPC 4 Setup: Single-stage cascaded SPC 4 Power only the SPC 4! (Power for SST not needed) Use the PSU4000 to power IVM and WMS Systems! NOTE: AKG recommends to use one SPC 4 / one antenna per 4 channels SST 4! Contact your local AKG dealer before using a single-stage cascaded SPC 4!

ملخص المحتوى في الصفحة رقم 4

SPC 4: Multichannel Conditions Headline RF Power Level at SST 4 10mW 20mw 50mW 100mW No. of channels 1 2 3 4 NOTE: AKG recommends to use only single SPC 4 setups! 5 6 7 8 9 10 11 ... Possible 12 13 ... Please contact your local AKG dealer 14 15 16 ... Not possible Single Cascaded SPC 4 SPC 4

ملخص المحتوى في الصفحة رقم 5

5 SPC 4: KEEP IN MIND!
Use only passive AKG antennas with SPC 4: SRA2W or RA4000W
Use short cable lengths between SPC 4 and antenna: Maximum is 10m for a RG58 cable
Set SST 4 RF output power according to slide: ‘SPC 4 Multichannel Conditions’
All connected SST 4 transmitters should operate in the same frequency band
LED Status  Green: System is working fine  Red: The antenna combiner has overheated or no AKG antenna is connected. The internal amplifier shuts down in both cases.
Th