PYLE Audio PYLE PylePro PDWM2200 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PDWM2700
TWO CHANNELS
VHF WIRELESS MICROPHONE
TRANSMITTER
USER'S MANUAL

ملخص المحتوى في الصفحة رقم 2

Thank you for choosing our VHF wireless microphone system. We strongly suggest that you carefully study these instructions before attempting to operate the system. CONTENTS P1----------Precautions P2----------Handheld microphone P3----------Belt Pack transmitter P4----------Receiver P5----------Installation P6----------Specifications P7----------Troubleshooting PRECAUTIONS 1. Avoid exposure of the system to rain or moisture. 2. No user-serviceable parts inside the system. Refer all servicing t

ملخص المحتوى في الصفحة رقم 3

HANDHELD MICROPHONE TROUBLE SHOOTING Please read and check the following points before asking for service. The wireless microphone fails fo work: --Check the microphone battery by switching the microphone ON. If power LED indicator lights red, replace the battery. --Check the POWER indicator on the receiver unit is ON. If not, check the mains power adapter is firmly plugged into a working mains socket. --Check the amplifier system is ON and the microphone controls set correctly. --Check the r

ملخص المحتوى في الصفحة رقم 4

SPECIFICATIONS BELT PACK TRANSMITTER A. Overall system 1. Oscillation mode: Quartz controlled BATTERY COVER 9V BATTERY MIC IN 2. Carrier Frequency Range VHF160~270MHz 3. Frequency Stability: +/-0.005% 4. Max Deviation: +/-56KHz with level limiting 5. Dynamic Range: >110dB POWER INDICATOR 6. S/N Ratio: >100dB POWER SWITCH 7. T. H. D: <0.5dB 8. Frequency Response 60Hz-18KHz OPEN CLOSE 9. Operating Range: 30M B. Receiver 1. Sensitivity: 6dB V at SIN >70dB 2. Image Rejection: >60dB 3. Stability: >8

ملخص المحتوى في الصفحة رقم 5

RECEIVER INSTALLATION To connect the wireless microphone to your amplifier system: Refer to the installation diagram below. Using the supplied 6.35mm to 6.35mm lead, connect from the AF CHA SIGNAL CHB SIGNAL OUT jack of the receiver to the MIC INPUT socket on your amplifier. Plug one end of the mains power adapter into a suitable mains socket. Plug the other end of the adapter into receiver DC 12V input socket. 1. Switch on the wireless microphone receiver unit by pressing the POWER