ملخص المحتوى في الصفحة رقم 1
Dual Receiver VHF Wireless Microphone System
ملخص المحتوى في الصفحة رقم 2
CONTENTS CONTENTS ....................................................................................................2 INTRODUCTION .............................................................................................2 USING THIS MANUAL .....................................................................................2 SYSTEM FEATURES ..........................................................................................3 ENCORE DUET RECEIVER ....................................
ملخص المحتوى في الصفحة رقم 3
SYSTEM FEATURES • Dual channel system for simultaneous operation of two transmitters • A vailable on two selected frequencies in the VHF high band (171-216 MHz) for interference‑free, long‑range performance • Proprietar y companding circuitr y for an industr y-best 120dB Dynamic Range, and the clearest, most natural sound available • Operating Range: Up to 250 feet typical (depending on site conditions)— up to 500+ feet line-of-sight • Noise-free transmitter ON/OFF operation • Rugged,
ملخص المحتوى في الصفحة رقم 4
ENCORE DUET RECEIVER 1. Rackmounting the Receiver There are two options available for rackmounting the Encore DUET receiver: singly or side‑by‑side with another Encore Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (as shown) and slide in the optional ERM-12 RACK EARS (9). b. Side-by-side double mounting: After removing the SIDE MOUNT CLIPS (1) from both Encore receivers, join the two receivers with the EJC-2 JOINING CLIP (10)
ملخص المحتوى في الصفحة رقم 5
5. Connecting the Audio Output The Encore DUET receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) for each channel and an adjustable line level A + B UNBALANCED AUDIO OUTPUT 1/4" JACK (13) which provides a mixed (summed) Ch A plus Ch B output signal. The mixed level from the A + B UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROLS (6) for each channel. (Note: As when making any connection, make sure the amplifier or mixing board volume is at the minimum
ملخص المحتوى في الصفحة رقم 6
16 16 7 8 4 5 5 4 2 14 6 13 11 6 14 2 15 1 9 9 1 12 10 12 6
ملخص المحتوى في الصفحة رقم 7
WHT HANDHELD MICROPHONE TRANSMITTER 1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the BATTERY HOLDER (18). Insert a fresh 9V ALKALINE BATTERY (19), observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can last up to 16 hours in use, but in order to ensure optimum per for mance, it is recommended that you replace the batter y after ever y 10 hours of use. 2. Turn on
ملخص المحتوى في الصفحة رقم 8
21 20 18 19 17 8
ملخص المحتوى في الصفحة رقم 9
WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (22) and insert a fresh 9V BATTERY (23), observing the correct polarity. Close the compartment. 2. The WLT is provided with a 3.5 mm LOCKING JACK (24) for connecting the microphone. Plug in either the LAVALIER/LAPEL (25) or the HEADWORN MICROPHONE (26), as supplied. To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. T o unplug, reverse the
ملخص المحتوى في الصفحة رقم 10
24 29 28 27 22 25 26 22 Opening Battery Compartment 23 10 BAT HI LOW MIC OFF/STANDBY/ON
ملخص المحتوى في الصفحة رقم 11
WGT INSTRUMENT BODYPACK TRANSMITTER 1. Snap open the BATTERY COMPARTMENT (30 ) and inser t a fresh 9V BATTERY (31), observing the correct polarity. Close the compartment. The WGT is provided with a 3.5 mm LOCKING JACK (32) for connecting the INSTRUMENT CABLE (35). To secure the connection, turn the metal slip ring on the plug clockwise to thread it on to the jack. T o unplug, reverse the process. Slip the transmitter into a pocket or clip on to your clothes or instrument strap. (Note: As
ملخص المحتوى في الصفحة رقم 12
35 34 33 32 30 30 Opening Battery Compartment 31 12
ملخص المحتوى في الصفحة رقم 13
SPECIFICATIONS ENCORE DUET OVERALL SYSTEM PERFORMANCE Frequency Response 25-20,000 Hz, +/-3dB Dynamic Range 120dB Total Harmonic Distortion < 0.3% RF Carrier Frequency Range 2 channels between 169-216 MHz Frequency Stability +/- 0.005%, cr ystal controlled Modulation FM (F3E), +/-20KHz max. Operating Range Up to 250 ft. typical (depending on site conditions); up to 500+ feet optimum line-of-sight ENCORE DUET RECEIVER Reception Mode Dual receivers (Channel A and Channel B) Controls Pow
ملخص المحتوى في الصفحة رقم 14
SERVICE INFORMATION In the U.S. If you are experiencing operational problems with your system, please refer to the Support page at www.nady.com for assistance. Should your wireless system require ser vice, please contact the Nady Ser vice Depar tment at (510) 652-2411 to obtain a Retur n Authorization (R/A) Number and ser vice quote (if out of warranty). Make sure the R/A Number is clearly marked on the outside of the package that you are returning. If your unit is out of warranty , pleas
ملخص المحتوى في الصفحة رقم 15
ONE-YEAR LIMITED WARRANTY Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workmanship for a period of one year from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace the unit free of charge, subject to verification of the defect or malfunction upon return to Nady Systems. Please do not return your Nady product to the store where it w
ملخص المحتوى في الصفحة رقم 16
Nady W ireless Systems are type accepted under FCC rules par ts 90, 74 and 15. The device complies with RSS-210 of Industr y & Science Canada. Operation is subject to the following two conditions: (1) this device may not cause har mful inter ference and (2) this device must accept any inter ference received, including interference that may cause undesired operation. 6701 Shellmound Street | Emeryville, CA USA 94608 | | T 510.652.2411 F 510.652.5075 www.nady.com
