ملخص المحتوى في الصفحة رقم 1
MODEL NO. PO14542D
14.5 HP 42 Inch
Lawn Tractor
For Parts and Service, contact our authorized distributor: call 1-800-849-1297
For Technical Assistance: call 1-800-829-5886
179416 4.20.01 TR
PRINTED IN U.S.A.
ملخص المحتوى في الصفحة رقم 2
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. GENERAL OPERATION DO NOT: • Read, understand, and follow all instructions in the manual • Do not turn on slopes unless necessary, and then, turn slowly and gradually downhill, if possible. and on the machine before starting. Only allow responsible
ملخص المحتوى في الصفحة رقم 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers Be sure the area is clear of other people before mowing. Look for this symbol to point out im- Stop machine if anyone enters the area. portant safety precautions. It means Never carry passengers or children even with the blades CAUTION!!! BECOME ALERT!!! YOUR off. SAFETY IS INVOLVED. Do not mow in reverse unless absolutely necessary. Al- ways look down and behind before and while backing. Never carry children. They may fall off
ملخص المحتوى في الصفحة رقم 4
CONGRATULATIONS on your purchase of a new tractor. It PRODUCT SPECIFICATIONS has been designed, engineered and manufactured to give GASOLINE CAPACITY 1.25 GALLONS you the best possible dependability and performance. AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) remedy, please contact your nearest authorized service SAE 5W-30 (below 32°F) center/department. We have competent, well-trained tech- nicians and the proper to
ملخص المحتوى في الصفحة رقم 5
UNASSEMBLED PARTS Steering Wheel Seat Steering Wheel Adapter Steering (1) Washer Extension 17/32 x 1-3/16 x 12 Gauge Shaft Steering Wheel (1) Lock Insert Washer 1/2 (1) Bolt Steering (1) Lockwasher 3/8 Boot (1) Locknut 5/16-18 (1) Large Flat Washer Keys (1) Hex Bolt 3/8-16 x 1 (1) Oil Drain Tube For Future Use (2) Keys Slope Sheet (1) Hex Bolt 5/16-18 x 1-1/4 5
ملخص المحتوى في الصفحة رقم 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard INSERT wrench sizes are listed. 3/8 HEX BOLT (1) 9/16" wrench Pliers (2) 1/2" wrenches Tire pressure g
ملخص المحتوى في الصفحة رقم 7
ASSEMBLY HOW TO SET UP YOUR TRACTOR SEAT CHECK BATTERY (See Fig. 2) Lift seat pan to raised position and open battery box door. If this battery is put into service after month and year SEAT PAN indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in CUSTOMER RESPONSIBILITIES section of this manual for charging instructions). SHOULDER BOLT SEAT PAN LABEL BATTERY FLAT WASHER BOX DOOR LOCK WASHER TERMINAL TERMINAL ADJUSTMENT BO
ملخص المحتوى في الصفحة رقم 8
ASSEMBLY TO DRIVE TRACTOR OFF SKID (See Opera- 3 CHECKLIST tion section, page 10, for location and func- BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- tion of controls) TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS WARNING: Before starting, read, understand and follow QUALITY PRODUCT. all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in PLEASE REVIEW THE FOLLOWING CHECKLIST: front of t
ملخص المحتوى في الصفحة رقم 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BATTERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING LIGHTS ON OVER TEMP ENGINE ON ENGINE OFF OIL PRESSURE LIGHT PARKING BRAKE UNLOCKED MOWER LIFT FUEL CHOKE MOWER HEIGHT LOCKED P ATTACHMENT REVERSE NEUTRAL HIGH LOW PARKING BRAKE CLUTCH ENGAGED 15 15 15 KEEP AREA CLEAR SLOPE HAZARDS ATTACHMENT (SEE SAFETY RULES SECTION) CLUTCH DISENGAGED IGNITION FREE WHEEL DANG
ملخص المحتوى في الصفحة رقم 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. ATTACHMENT LIGHT SWITCH CLUTCH LEVER IGNITION AMMETER SWITCH LIFT LEVER PLUNGER THROTTLE/CHOKE ATTACHMENT CONTROL LIFT LEVER CLUTCH/BRAKE PEDAL MOWER DECK HEIGHT ADJUSTMENT POSITIONS GEARSHIFT LEVER PARKING BRAKE FIG. 4 Our tractors con
ملخص المحتوى في الصفحة رقم 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD). TO SET PARKING BRAKE (See
ملخص المحتوى في الصفحة رقم 12
OPERATION TO ADJUST GAUGE WHEELS (See Fig. 6) CAUTION: Do not operate the mower Gauge wheels are properly adjusted when they are slightly without either the entire grass catcher, off the ground when mower is at the desired cutting height in on mowers so equipped, or the deflector shield in place. operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. TO OPERATE ON HILLS NOTE:Adjust gauge wheels with tractor on a flat level su
ملخص المحتوى في الصفحة رقم 13
OPERATION COLD WEATHER STARTING ( 50° F and below) ADD GASOLINE When engine starts, allow engine to run with the throttle Fill fuel tank. Use fresh, clean, regular unleaded control in the choke position until the engine runs gasoline with a minimum of 87 octane. (Use of leaded roughly, then move throttle control to fast position. This gasoline will increase carbon and lead oxide deposits may require an engine warm-up period from several and reduce valve life). Do not mix oil with gasolin
ملخص المحتوى في الصفحة رقم 14
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T R Check for Loose Fasteners 7 A Sharpen/Replace Mower Blades 4 C Lubrication Chart T Check Battery Level 6 0 Clean Battery and Terminals R Check Transaxle Cooling Adjust Blade Belt(s) Tension 5 Adjust Motion Drive Belt(s) Tension 5 Check Engine Oil Level Change Engine Oil 1 1,2,3 Clean Air Filter 2 E C
ملخص المحتوى في الصفحة رقم 15
CUSTOMER RESPONSIBILITIES TRACTOR MANDREL TRAILING ASSEMBLY EDGE UP Always observe safety rules when performing any mainte- nance. CENTER HOLE BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Adjustments section of this manual). STAR LOCK WASHER TIRES BLADE Maintain proper air pressure in all tires (See “PRODUCT SPECIFICATIONS” section of this manual). FLAT WASHER
ملخص المحتوى في الصفحة رقم 16
CUSTOMER RESPONSIBILITIES BATTERY TO CHANGE ENGINE OIL (See Figs. 11 and 12) Your tractor has a battery charging system which is suffi- Determine temperature range expected before oil change. cient for normal use. However, periodic charging of the All oil must meet API service classification SF-SJ. battery with an automotive charger will extend its life. Be sure tractor is on level surface. Keep battery and terminals clean. Oil will drain more freely when warm. Keep battery bolts tight.
ملخص المحتوى في الصفحة رقم 17
CUSTOMER RESPONSIBILITIES AIR FILTER (See Fig. 14) CLEAN AIR SCREEN Your engine will not run properly using a dirty air filter. Clean Air screen must be kept free of dirt and chaff to prevent the foam pre-cleaner after every 25 hours of operation or engine damage from overheating. Clean with a wire brush or every season. Service paper cartridge every 100 hours of compressed air to remove dirt and stubborn dried gum fibers. operation or every season, whichever occurs first. ENGINE COOLING FINS
ملخص المحتوى في الصفحة رقم 18
CUSTOMER RESPONSIBILITIES MUFFLER Inspect and replace corroded muffler and spark arrester (if CLAMP equipped) as it could create a fire hazard and/or damage. CLAMP SPARK PLUGS Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever FUEL occurs first. Spark plug type and gap setting are shown in FILTER “PRODUCT SPECIFICATIONS” section of this manual. FIG. 15 IN-LINE FUEL FILTER (See Fig. 15) The fuel filter should be replaced once each season.
ملخص المحتوى في الصفحة رقم 19
SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key “OFF” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. Disconnect front links from deck by removing
ملخص المحتوى في الصفحة رقم 20
SERVICE AND ADJUSTMENTS When distance “D” is 1/8" to 1/2" lower at front than rear, TO LEVEL MOWER HOUSING tighten nuts “F” against trunnion on both front links. Adjust the mower while tractor is parked on level ground or To raise front of mower, loosen nut “F” from trunnion on driveway. Make sure tires are properly inflated (See “PROD- both front links. Tighten nut “E” on both front links an UCT SPECIFICATIONS” section of this manual). If tires are equal number of turns. over or underinf
