ملخص المحتوى في الصفحة رقم 1
Safety Instructions & Operator's Manual for
LAWN TRACTOR
SERIES 0
Models
LT23460AWS (49-State) (7800478)
LT23460AWS (California) (7800541)
NOTE: Specifications are correct at time of printing and are subject to change without notice.
* Actual sustained engine power will likely be lower due to operating limitations and environmental factors. Please refer to ‘Engine Power Rating Information’ for further
details.
Manual No. 7102845 (Rev. ‘-’, 2/18/2009)
ملخص المحتوى في الصفحة رقم 2
Thank you for purchasing this quality-built Snapper product. We are pleased that you’ve placed your confidence in the Snapper brand. When operated and maintained according to the instructions in this manual, your Snapper mower will provide many years of dependable service. This manual contains safety information to make you aware of the hazards and risks associated with mowers and how to avoid them. Because Snapper does not necessarily know all the applications this mower could be used for, it i
ملخص المحتوى في الصفحة رقم 3
Table of Contents Operator Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Important Operator Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 International Pictorials. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Parts Bag - Contents . . . . . . . . . . . . . . . . . . . . . . . . . . .
ملخص المحتوى في الصفحة رقم 4
! ! Important Operator Safety Instructions WARNING: This powerful cutting machine is capable of amputating hands and feet and can throw objects that can cause injury and damage! Failure to comply with the following SAFETY instructions could result in serious injury or death to the operator or other persons. The owner of the machine must understand these instructions and must allow only persons who understand these instructions to operate machine. Each person operating the machine must be of soun
ملخص المحتوى في الصفحة رقم 5
! ! Important Operator Safety Instructions (Continued) Protection against Tipovers Operation (Continued From Previous Column) 1. Mount and dismount machine from left side. Keep clear 7. Keep people and pets out of mowing area. Immediately of discharge opening at all times. STOP blades, STOP engine, and STOP machine if anyone 2. Start engine from operator’s seat, if possible. Make sure enters the area. blades are OFF and parking brake is set. 8. Check shields, deflectors, switches, blade control
ملخص المحتوى في الصفحة رقم 6
! ! Important Operator Safety Instructions (Continued) Towing Maintenance 1. Tow only with a machine that has a hitch designed for (Continued From Previous Column) towing. DO NOT attach towed equipment except at the hitch 6. Always provide adequate ventilation when running point. engine. Exhaust gases contain carbon monoxide, an 2. Follow the manufacturer’s recommendation for weight odorless and deadly poison. limits for towed equipment and towing on slopes. 7. Disconnect negative (black) cable
ملخص المحتوى في الصفحة رقم 7
International Pictorials IMPORTANT: Some of the following pictorials are located on your unit or on literature supplied with the product. Before you operate the unit, learn and understand the purpose for each pictorial. F C E D B A max 15° K G J H I max± 90N max± 150N N M L P O Figure 1: Safety warning pictorials A - Warning G - WARNING: Thrown Objects. Keep K - DANGER: Keep Feet And Hands B - Shield Eyes. Explosive Gases Can Bystanders Away. Read User Away From Rotating Blade. Cause Blindness
ملخص المحتوى في الصفحة رقم 8
WARNING: Before doing any assembly or Assembly maintenance to the mower, remove the wire from the Read and follow the assembly and adjustment spark plug. instructions for your mower. All fasteners are in the parts bag. Do not discard any parts or material until the unit is assembled. NOTE: In this instruction book, left and right describe the location of a part with the operator on the seat. Parts Bag - Contents The fasteners and other loose parts are shown below. The fasteners are shown full
ملخص المحتوى في الصفحة رقم 9
Installing the Seat Assembling the Steering Wheel How to Assemble the Steering Wheel How to Install the Seat Tools Required: 3/8" Socket Wrench 1. Carefully remove the plastic bag from the seat. Use the fasteners shown below to install the seat. The fasteners Attach the steering wheel as follows: are shown at full size. A B A B Figure 6: Steering wheel parts A - Screw (Also see ‘C’ in Figure 3) Figure 4: Seat parts B - Washer (Also see ‘D’ in Figure 3) A - Wing bolt (Also see ‘E’ in Figure 3) 1.
ملخص المحتوى في الصفحة رقم 10
Maintenance Free Battery C IMPORTANT: Before you attach the battery cables to the D battery, check the battery date. The battery date tells if the battery must be charged. A 1. Check the top and the side of the battery for the B location of the battery date (Figure 9). 2. If the battery is put into service before the battery date, E the battery cables can be attached without charging the battery. See “How To Install The Battery Cables”. 3. If the battery is put into service after the battery
ملخص المحتوى في الصفحة رقم 11
1. Remove the protective cap from the battery terminal. Operator Presence System (Seat) 2. Fasten the red cable and terminal cover (if equipped) to The seat has an Operator Presence System to shut off the the positive (+) terminal with the fasteners as shown engine when the operator leaves the seat. This system is not (Figure 9). intended for regular use in stopping the engine or the blade(s). Before leaving the seat, move the blade rotation 3. Fasten the black cable to the negative (-) termina
ملخص المحتوى في الصفحة رقم 12
How to Prepare the Engine Check the Tires NOTE: The engine was shipped from the factory filled with NOTE: The tires may be over inflated for shipment. oil. Check the level of the oil. Add oil as needed. Check the air pressure in the tires. Tires with too much air NOTE: The operation of a new engine will sometimes result pressure will cause the unit to ride rough. Also, the wrong in a slight amount of smoke. This smoke is caused by paint air pressure will keep the mower housing from cutting lev
ملخص المحتوى في الصفحة رقم 13
Features and Controls E F A G H I B J C D G - Reverse Mowing Option (RMO) — Allows engaging of A - Throttle Control / Choke Control Levers — Throttle mowing deck while traveling in reverse. control increases or decreases the speed of the engine. Choke control engages the choke to start a cold engine. H - Ignition Switch — Starts and stops the engine. (Note: The headlight switch is incorporated into the ignition switch.) B - Steering Wheel (Removed for clarity) — Steers the unit. I - Parking B
ملخص المحتوى في الصفحة رقم 14
Using Controls Operation How to Use the Throttle Control Attachments Use the throttle control to increase or decrease the speed of This unit can use many different attachments. the engine. For all pull-behind attachments or trailers, the maximum CAUTION: Always operate the engine with the throttle control gross weight is 250 pounds. Gross weight is the weight of in the FAST position. If the engine runs for several minutes the attachment or trailer and any load that might be on or in at slower t
ملخص المحتوى في الصفحة رقم 15
How to Engage the Blades How to Use the Speed Control Pedal The PTO switch is above and to the right of the steering The drive system uses a Hydrostatic Automatic Drive wheel (Figure 10). Use the PTO switch to engage the blades. transmission. The Hydrostatic transmission is very easy to operate. This type of drive system does not require a shift lever or a clutch pedal. The speed and direction of travel is controlled by a single speed control pedal operated with your right foot. Do not use the l
ملخص المحتوى في الصفحة رقم 16
How to Use the Cruise Control How to Drive in Reverse To engage the cruise control: 1. Look to the rear. 1. Slowly push the speed control pedal forward to the 2. Slowly push the speed control pedal to the REVERSE desired speed (Figure 11). position. 2. Pull up on the cruise control knob (Figure 12). Release How to Change Direction the speed control pedal. The unit should continue CAUTION: To change directions, do not use the left brake traveling forward at the desired speed. pedal. Use only th
ملخص المحتوى في الصفحة رقم 17
How to Change the Cutting Height To change the cutting height, raise or lower the deck ift lever as follows: 1. Move the deck lift lever forward to lower the mower housing and back to raise the mower deck (Figure 15). 2. When you ride on a sidewalk or road, move the deck lift A lever to the highest position and disengage the blades (Figure 10). A B Figure 13: Automatic drive disconnect A - Automatic drive disconnect DRIVE position B - Automatic drive disconnect PUSH position How to Set the Par
ملخص المحتوى في الصفحة رقم 18
How to Transport the Unit Reverse Mowing Option (RMO) To transport the unit, follow the steps below. WARNING: Mowing in reverse can be hazardous to bystanders. Tragic accidents can occur if the 1. Disengage the blades. operator is not alert to the presence of children. 2. Raise the deck lift lever to the highest position. Never activate RMO if children are present. Children 3. Move the throttle control to the FAST position. are often attracted to the unit and the mowing 4. Slowly push the spee
ملخص المحتوى في الصفحة رقم 19
How to Operate the Unit on Hills All-Wheel Steering WARNING: Do not ride up or down slopes that are Because both front and rear wheels turn, the tractor is very too steep to back straight up. Never ride the unit maneuverable. Because of the shorter turning radius, the across a slope. See the “Slope Guide” in the back of tractor can operate closely around objects, such as shrubs this book for information on how to check slopes. and trees. However, because the rear wheels turn toward the object,
ملخص المحتوى في الصفحة رقم 20
Carburetor Engine Operation Do not attempt to adjust the carburator. Engine adjustments Before Starting the Engine and repairs should be performed only by an authorized dealer. Check the Oil NOTE: The engine was shipped from the factory filled with oil. Check the level of the oil. Add oil as needed. See the How to Start the Engine engine manufacturer’s instructions for the type of gasoline and oil to use. WARNING: The electrical system has an operator presence system that includes a sensor swit
