ملخص المحتوى في الصفحة رقم 1
2008-01
Operator's
Manual O0802013
Ride Mower
2748 GLS
96043004600
03002
Operator's Manual
ملخص المحتوى في الصفحة رقم 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and cidental starting when setting up, working. transporting, ad justing or making • Slow down before turning
ملخص المحتوى في الصفحة رقم 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers GENERAL SERVICE III. CHILDREN • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to • Keep all nuts and bolts tight to be sure the equipment is in safe working condition. the ma chine and the mowing activity. Never assume that children will remain where you last saw them. • Never tamper with safety devices. Check their proper • Ke
ملخص المحتوى في الصفحة رقم 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES Gasoline Capacity 4 Gallons • Read and observe the safety rules. and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for Oil Type (API-SG-SL): SAE 30 (above 32°F) and using your tractor. SAE 5W-30 (below 32°F) • Follow the instructions under “Maintenance” and “Stor- Oil Capacity: w/Filter: 64 oz age” sec tions of this own er’s manual. w/o Filter: 60 oz Spark Plug: Champion QC12YC (Gap: .040") WARNIN
ملخص المحتوى في الصفحة رقم 5
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. (1) 3/4" wren
ملخص المحتوى في الصفحة رقم 6
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. CHECK FOR PROPER POSITION OF ALL Follow the ap propriate instruction below to remove the BELTS tractor from the skid. See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments WARNING: Before start ing, read, un derstand and fol low section of this manual. Verify that the belts are routed all in structions in the Op eration section of this man ual. Be correctly. sure
ملخص المحتوى في الصفحة رقم 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFETY
ملخص المحتوى في الصفحة رقم 8
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad justments. Save this manual for future reference. H D E G P B N F J C Q A M FIG. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER – Used to raise and lower (G) REVERSE OPERATION SYSTEM (ROS) "ON" PO- the
ملخص المحتوى في الصفحة رقم 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per forming any adjustments or repairs. We rec ommend a wide vision safety mask over spectacles or stan dard safety glasses. IMPORTANT: Leaving the ignition switch in any position HOW TO USE YOUR TRAC TOR other than "STOP" will cause the battery to discharge and go dead. TO SET PARKIN
ملخص المحتوى في الصفحة رقم 10
OPERATION TO MOVE FORWARD AND BACKWARD NOTE: Adjust gauge wheels with tractor on a flat level (See Fig. 7) surface. The direction and speed of movement is controlled by the • Adjust mower to desired cutting height (See “TO AD- Motion Control Lever (J). JUST MOWER CUT TING HEIGHT” in this sec tion of manual). • With mower in desired height of cut po sition, gauge wheels should be assembled so they are slightly off the ground. In stall gauge wheel in ap propriate hole. Tighten se curely. •
ملخص المحتوى في الصفحة رقم 11
OPERATION NOTE: To protect hood from damage when transporting WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator hood to tractor (rope, cord, etc.). decides it is necessary to reposition the machine with the
ملخص المحتوى في الصفحة رقم 12
OPERATION COLD WEATHER STARTING ( 50° F and below) ADD GASOLINE • When engine starts, allow engine to run with the throttle • Fill fuel tank to bottom of filler neck. Do not overfill. Use control in the choke position until the engine runs roughly, fresh, clean, regular un leaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon then move throttle control to fast position. This may re- and lead oxide deposits and reduce valve life). Do not quire an engin
ملخص المحتوى في الصفحة رقم 13
OPERATION • Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. Disengage parking brake. • Drive tractor forward for approximately five feet then backwards for five feet. Repeat this driving procedure three times. Your transmission is now purged and now ready for normal operation. MOWING TIPS • Mower should be properly leveled for best mowing FIG. 12 performance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments se
ملخص المحتوى في الصفحة رقم 14
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
ملخص المحتوى في الصفحة رقم 15
02545 MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be sharp. Re place Always observe safety rules when per forming any main- worn, bent or damaged blades. tenance. CAUTION: Use only a replacement BRAKE OPERATION blade approved by the manufacturer of If tractor requires more than five (5) feet to stop at highest your tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is surface, then brake m
ملخص المحتوى في الصفحة رقم 16
MAINTENANCE • Rinse the battery with plain water and dry. TO CHANGE ENGINE OIL (See Figs. 14 and 15) • Clean terminals and battery cable ends with wire brush Determine temperature range expected before oil change. until bright. All oil must meet API service classification SG-SL. • Coat terminals with grease or petroleum jelly. • Be sure tractor is on level surface. • Reinstall battery (See “REPLACING BATTERY" in • Oil will drain more freely when warm. the SERVICE AND ADJUSTMENTS section of t
ملخص المحتوى في الصفحة رقم 17
MAINTENANCE ENGINE OIL FILTER 2. Make sure the PTO (Blade Engage) is not engaged, Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in set the parking brake, and stop the engine. one year. 3. Thread the nozzle adapter (packaged with your tractor’s Operator’s Manual) onto the end of your garden hose. MUFFLER Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- Hose age.
ملخص المحتوى في الصفحة رقم 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST- MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. • From right side of mower, disconnect anti-sway bar (S) TRACTOR
ملخص المحتوى في الصفحة رقم 19
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer spring. • Repeat on opposite side of tractor. C A D 02965 NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under tractor until it is centered under FIG. 21 tractor. • ATTACH REAR LIFT LINKS (C) - Lift rear corner of • FIRST INSTALL ANTI-SWAY BAR (S).
ملخص المحتوى في الصفحة رقم 20
SERVICE AND ADJUSTMENTS • Engage belt tension rod (K) on locking bracket (L). • Raise attachment lift lever to highest position. • If necessary, adjust gauge wheels before op erating CAUTION: Belt tension rod is spring mower as shown in the Operation section of this loaded. Have a tight grip on rod and manual. engage slowly. B M L F K A E H S C D FIG. 24 NOTE: As desired, you can raise the low side of mower TO LEVEL MOWER or lower the high side. Make sure tires are properly inflated to the PS
