ملخص المحتوى في الصفحة رقم 1
Operator’s Manual
21” Hi-Wheel Mower
Models 546 & 549
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-cov-
ered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable
local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State
of California the above is required by law (Sec
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENTS Content Page Content Page Important Safe Operation Practices 3 Maintaining Your Lawn Mower 12 Slope Gauge 6 Servicing Your Lawn Mower 12 Assembling Your Lawn Mower 7 Troubleshooting 13 Know Your Lawn Mower 9 Illustrated Parts List 14 Operating Your Lawn Mower 10 Warranty 16 Making Adjustments 11 FINDING MODEL NUMBER This Operator’s Manual is an important part of your new lawn mower. It will help you assemble, prepare and maintain the unit for best performance. Please read and
ملخص المحتوى في الصفحة رقم 3
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol—HEED ITS WARNING. WARNING: Engine exhaust, some of its constituents, and certain vehicle components
ملخص المحتوى في الصفحة رقم 4
immediately and the blade will stop rotating within 3. Do not mow on wet grass. Unstable footing could three seconds. cause slipping. 9. Mow in daylight or good artificial light; walk, not run. 10. Stop the blade when crossing gravel drives, Children walkways or roads. Tragic accidents can occur if the operator is not alert to 11. If the equipment should start to vibrate abnormally, the presence of children. Children are often attracted to stop the engine and check immediately for the the
ملخص المحتوى في الصفحة رقم 5
10. Never over fill fuel tank. Fill tank to no more than ½ 4. Mower blades are sharp and can cut. Wrap the inch below bottom of filler neck to provide space for blade or wear gloves, and use extra caution when fuel expansion. servicing them. 11. Replace gasoline cap and tighten securely. 5. Keep all nuts, bolts, and screws tight to be sure the 12. If gasoline is spilled, wipe it off the engine and equipment is in safe working condition. equipment. Move unit to another area. Wait 5 6. Never ta
ملخص المحتوى في الصفحة رقم 6
FOLD ON DOTTED LINE, REPRESENTING A 15° SLOPE SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLE A CORNER OF A BUILDING OR A FENCE POST 15° WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk-behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious injury. Operate RIDING mowers u
ملخص المحتوى في الصفحة رقم 7
SECTION 3: ASSEMBLING YOUR LAWN MOWER Removing Unit From Carton Lower Handle Remove staples, break glue on top flaps, or cut tape at carton end and open carton. Handle Upper Remove loose parts if included with unit (i.e., Bracket Handle operator’s manual, etc.) Cut along corners, lay the carton down flat, and remove all packing material. Roll or slide unit out of carton and check carton thoroughly for loose parts. Loose Parts in Carton Grass Bag Figure 2 Side Discharge Chute
ملخص المحتوى في الصفحة رقم 8
Fasten the cable to the lower handle with the two Assembling Grass Catcher cable ties found on the lower handle. Pull the cable ties tight and trim off the excess. See Figure 5. NOTE: If the grass catcher came pre-assembled, proceed to the next section. If it came unassembled, Cable Tie follow the steps below to assemble it first, before attaching to the mower. Insert frame into grass bag with the black plastic Lower side on the bottom of bag. See Figure 8. Handle Slip the openings in
ملخص المحتوى في الصفحة رقم 9
IMPORTANT: Do not remove the mulching plug at any Rear Discharge Door time, even when you are not mulching. Mulching Plug Hinge Grass Catcher Pin Side Chute Deflector Figure 9 Figure 10 To remove the grass catcher, lift the rear discharge door on the mower, lift the grass catcher up and off Using Mulch Plug the pivot rod. Release the rear discharge door. Lift the mulch plug and remove the discharge chute up and away from the mower. Let mulch plug rest Attaching Side-Discharge Chute agai
ملخص المحتوى في الصفحة رقم 10
grass catcher and the side-discharge chute from the Grass Catcher mower, and operate with the mulching plug only for this The grass catcher, located at the rear of the mower, is purpose. used to bag the grass clippings for disposal at another site. Once the bag is full, it has to be removed from the mower and emptied before any further mowing. Mulching Plug Instead of collecting grass clippings in a grass catcher, this mower has the option of recirculating the clippings back to the lawn.
ملخص المحتوى في الصفحة رقم 11
For a healthy lawn, always cut off one-third or less Bagging Grass Clippings of the total length of the grass. You can use the grass catcher bag to collect clippings while you are operating the mower. Mulching Attach grass catcher following instructions on page For effective mulching, do not cut wet grass. New or 8 of this manual. Grass clippings will automatically thick grass may require a narrower cut. If the grass has collect in the bag as you run the mower. grown in excess of 4”
ملخص المحتوى في الصفحة رقم 12
SECTION 7: MAINTAINING YOUR LAWN MOWER Put the mower back on its wheels on the ground. If WARNING: Always stop the engine and you had put plastic under the gas cap, make sure to disconnect the spark plug wire before remove it now. performing any maintenance work or adjustments on your lawn mower. Lubrication Blade Control Handle Cleaning Mower Lubricate the pivot points on the blade control The underside of the mower deck should be cleaned handle at least once a season with light oil
ملخص المحتوى في الصفحة رقم 13
Follow the original angle of grind as a guide. Make Place blade bell support on blade. Make sure the sure that each cutting edge receives an equal notches on the blade bell support are aligned with amount of grinding to prevent an unbalanced blade. small holes in the blade. Replace hex bolt and tighten hex bolt to torque: 450 WARNING: An unbalanced blade will cause in. lbs. min., 600 in. lbs. max. excessive vibration when rotating at high NOTE: To ensure safe operation of your mower,
ملخص المحتوى في الصفحة رقم 14
SECTION 10: PARTS LIST FOR MODELS 546 & 549 30 3 1 10 2 8 5 6 11 9 49 7 18 19 53 50 14 4 25 52 15 13 40 37 38 55 56 41 40 51 42 12 47 25 34 36 57 33 44 59 54 47 25 32 35 39 31 58 25 28 48 29 26 27 25 20 60 25 45 22 24 43 21 17 16 23 46 14
ملخص المحتوى في الصفحة رقم 15
PARTS LIST FOR MODELS 546 & 549 Ref. Ref. Part No. Part Description Part No. Part Description No. No. 1. 747-1161A Control Handle 33. 687-02074 Front Height Adjuster Assembly — RH 2. 749-1092A Upper Handle 687-02075 Front Height Adjuster Assembly — LH 3. 747-04080 Grass Bag Frame 34. 687-02039 Pivot Arm Assembly — RH 4. 749-0928A Lower Handle 687-02040 Pivot Arm Assembly — LH 5. 720-0279 Wing Nut 35. 782-5002B Front Baffle 6. 710-1205 Rope Guide 36. 710-0654A Hex Washer Screw 3/8-16 x 1.0
ملخص المحتوى في الصفحة رقم 16
MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC e. Troy-Bilt does not extend any warranty for products with respect to new merchandise purchased and used in the sold or exported outside of the United States, its United States, its possessions and territories. possessions and territories, except those sold through Troy-Bilt’s authorized channels of export distribution. “Troy-Bilt” warrants this product against defects in material f. Replacem
