Perlick DS1KP دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION and TAPPING
PARTYMASTER DISPENSER
Connecting the Keg Coupler (when supplied by Perlick)
1. Place one brown leather washer into black beer line connector hose on hex nut
side. Screw connector to stainless steel beverage line on faucet standard. Tighten with
a wrench, but do not over tighten.
2. Make sure lever handle on keg coupler is in the UP (untapped) position. Place one
brown leather washer into wing nut end of black beer line connector hose and thread
onto top of keg coupler.

ملخص المحتوى في الصفحة رقم 2

INSTALLATION and TAPPING PARTYMASTER DISPENSER Connecting the Regulator to the CO2 Cylinder CO2 Pressure Hand Gauge Valve 1. Remove blue plug from regulator fitting. (Note: Do not remove the carbonic washer.) Regulator 2. Screw regulator onto gas cylinder valve. Tighten Fitting with wrench until vertically straight. Be sure that shut-off valve (black lever) on regulator is in CO2 Gas OFF (horizontal) position. Drum 3. Place a screw clamp over end of red air line and push onto regulator tailpiec