Snapper 7-4172 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

DEALER SET-UP INSTRUCTIONS for SNAPPER
21” STEEL DECK WALK BEHIND MOWERS

This SNAPPER Walk Behind Mower uses a handle engine control bail system to kill the engine for the SAFETY of
the operator. These mowers are designed for quick set-up. The Pre Sale Checklist must be completed and filled
out by the dealer as the items are checked off and/or performed and the Consumer/Operator Product Registration
card filled out and sent to the Customer Service department at SNAPPER when completed. C

ملخص المحتوى في الصفحة رقم 2

STEP 5: Handle height is adjustable for different height of STEP 6: Set-up is now complete for push models operators. Loosen the two nuts on the inside of each of without self-propelled drive system. For self-propelled the lower handles. See Figure 4. Move the handle up or models continue to the “Self-Propelled Models” Section. down to the desired height.. Retighten all nuts securely Proceed to the Pre Sale Checklist section of this after adjustment. Pull blade control against upper handle,

ملخص المحتوى في الصفحة رقم 3

STEP 8: Driven disc to drive disc adjustment is set up at C. Slide driven disc assembly over until 1/8” from the factory. In case driven disc may need adjustment, outside edge of drive disc. Maintaining the 1/8” proceed as follows: measurement, remove any looseness from the linkage. This can be done by holding the transfer rod and A. Place speed control rod in the number six speed applying pressure to the left (as viewed from operators position. See Figure 7. position), then retighten the

ملخص المحتوى في الصفحة رقم 4

STEP 10: Install the grass bag adapter and secure to STEP 12: Fold bag opening into a "Z" and install slider. the side of the deck with the two 5/16-18 nuts (P/N 9- See Figure 16. 0951) provided in the hardware bag. See Figure 14. GRASP SLIDER. PULL Z-FOLD INTO SLIDER FIGURE 15 SECURE ADATER TO DECK WITH NUTS PULL FIGURE 16 STEP 13: Install grass bag on the mower. Slide bag connector over flange on the bag adapter. Attach grass bag handle to middle handle c

ملخص المحتوى في الصفحة رقم 5

DEALER PRE SALE CHECKLIST for SNAPPER 21” STEEL DECK WALK BEHIND MOWERS The following must be completed prior to sale. Refer to the previous pages in this instruction for detailed set- up instructions. Review this checklist with purchaser. Check (✓ ) all items actually performed and sign this checklist. SET-UP CHECKLIST _____ FOAM SHIPPING BLOCK removed from cutting blade. _____ UPPER HANDLE & LOWER HANDLE secured in place and hardware tightened securely. _____ SIDE CHUTE, RECYCLING