ملخص المحتوى في الصفحة رقم 1
IMPORTANT MANUAL Do Not Throw Away
OPERATOR'S MANUAL
WARNING:Read this Man u al
and follow all Warnings and Safety
MODEL:
Instructions. Fail ure to do so can
re sult in serious in ju ry.
PB19546LT
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
12.21.09 SR
432448 Printed in U.S.A.
ملخص المحتوى في الصفحة رقم 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Slow down before turning. WARNING: In order to prevent ac ci den tal • Never leave a running machine unattended. Always starting when setting up, trans port ing, turn off blades, set parking brake, stop engine, and ad just ing or making repairs,
ملخص المحتوى في الصفحة رقم 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN Tragic accidents can occur if the operator is not alert to GENERAL SERVICE the presence of children. Children are often attracted to • Never operate machine in a closed area. the ma chine and the mowing activity. Never assume that • Keep all nuts and bolts tight to be sure the equipment children will remain where you last saw them. is in safe working condition. • Keep children out of the mowing area and in the watchful
ملخص المحتوى في الصفحة رقم 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give you the best possible dependability and performance. Gasoline Capacity 1.50 Gallons and Type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type (API-SG-SL): SAE 30 (above 32°F) edy, please contact your nearest authorized service center/ SAE 5W-30 (below 32°F) department. We have com pe tent, well-trained tech ni cians a
ملخص المحتوى في الصفحة رقم 5
UNASSEMBLED PARTS Keys Slope Sheet (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard LABEL wrench sizes are listed. (1) 1/2" wrench Tire pressure gauge (2) 7/16" wrenches Utility knife Pliers When right or left hand is mentioned in this man ual, it means when you are in the operating po si tion (seated be hind the ste
ملخص المحتوى في الصفحة رقم 6
ASSEMBLY NOTE: You may now roll your tractor off the skid. Follow the ✓CHECKLIST instructions below to remove the tractor from the skid. BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- WARNING: Before start ing, read, un der stand and fol low FOR MANCE AND SAT IS FAC TION FROM THIS QUALITY all in struc tions in the Op er a tion section of this man u al. Be PROD UCT. sure tractor is in a well-ventilated area. Be sure the area in front of tractor
ملخص المحتوى في الصفحة رقم 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH P ENGINE ON ENGINE START PARKING BRAKE ENGINE OFF REVERSE PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) FUEL OIL PRESSURE BATTERY REVERSE FORWARD OVER TEMP MOWER HEIGHT MOWER LIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPE HAZARDS CLUTCH ENGAGED DANGER, KEEP HANDS KEEP AREA CLEAR CLUTCH
ملخص المحتوى في الصفحة رقم 8
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ROS "ON" ROS "ON" POSITION POSITION L LIGHT IGHT S SWITCH WITCH THROTTLE/CHOKE THROTTLE/CHOKE C CONTROL ONTROL A AT TT TA ACHMENT CHMENT C CL LU UTCH LEVER TCH LEVER C CL LUTCH/BRAKE UTCH/BRAKE PEDAL PEDAL IIGNITION GNITION SWITCH
ملخص المحتوى في الصفحة رقم 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spec- tacles or stan dard safety glasses. HOW TO USE YOUR TRAC TOR • Turn ignition key (F) to “STOP” position and remove key. Always remove key when leaving tractor to prevent TO SET PARKING BRAKE (
ملخص المحتوى في الصفحة رقم 10
OPERATION • Start tractor with clutch/brake pedal depressed and gearshift lever in neutral position. • Move gearshift lever to desired po si tion. • Slowly release clutch/brake pedal to start move- ment. IMPORTANT: Bring tractor to a complete stop before shifting or changing gears. Failure to do so will shorten the useful life of your transaxle. TO ADJUST MOWER CUT TING HEIGHT (See Fig. 8) FIG. 9 The po si tion of the at tach ment lift le ver (A) de ter mines the cut ting height. REVER
ملخص المحتوى في الصفحة رقم 11
OPERATION TO OPERATE MOWER TOWING CARTS AND OTHER AT TACH - MENTS Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with Tow only the attachments that are recommended by and the engine running and the attachment clutch engaged will comply with specifications of the manufacturer of your trac- shut off the engine. You must remain fully and centrally tor. Use common sense when towing. Too heavy of a load, positioned in the seat t
ملخص المحتوى في الصفحة رقم 12
OPERATION TO START ENGINE (See Fig. 4) MOWING TIPS • Mower should be properly leveled for best mowing When starting the engine for the first time or if the engine per for mance. See "TO LEVEL MOWER HOUSING" in has run out of fuel, it will take extra cranking time to move the Service and Adjustments section of this manual. fuel from the tank to the engine. • The left hand side of mower should be used for trim- • Sit on seat in operating position, depress clutch/brake ming. pedal and set pa
ملخص المحتوى في الصفحة رقم 13
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level 1,2 Change Engine Oil (with
ملخص المحتوى في الصفحة رقم 14
MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any main- bent or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade If tractor requires more than five (5) feet to stop at highest approved by the manufacturer of your speed in high est gear on a level, dry concrete or paved tractor. Using a blade not approved surface, then brake must be checked and ad just ed. by the manufa
ملخص المحتوى في الصفحة رقم 15
MAINTENANCE TO CLEAN BATTERY AND TERMINALS CAUTION: If engine has been operated Corrosion and dirt on the battery and terminals can cause for an extended period of time immedi- the battery to “leak” power. ately prior to draining oil, oil will be hot. • Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor. OIL DRAIN HOLE • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush until bright. OIL DRAIN •
ملخص المحتوى في الصفحة رقم 16
MAINTENANCE • Keep finished surfaces and wheels free of all gasoline, CLEAN AIR SCREEN oil, etc. Air screen must be kept free of dirt and chaff to prevent • Protect painted surfaces with automotive type wax. engine dam age from overheating. Clean with a wire brush We do not recommend using a garden hose or pressure or com pressed air to re move dirt and stubborn dried gum washer to clean your tractor unless the engine and trans- fibers. mission are covered to keep water out. Water in engin
ملخص المحتوى في الصفحة رقم 17
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: • Depress clutch/brake pedal fully and set parking brake. • Place gearshift lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
ملخص المحتوى في الصفحة رقم 18
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 22 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 20 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
ملخص المحتوى في الصفحة رقم 19
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 27 & 28) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 25) IMPORTANT:
ملخص المحتوى في الصفحة رقم 20
SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 29) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake. E BELT REMOVAL - • Remove mower from tractor (See “TO REMOVE MOW ER” in this section of manual). • Work belt off both mandrel pulleys and idler pulleys. F • Pull belt away from mower. BELT INSTALLATION - A • Work belt around both mandrel pulleys and idler pulleys. G • Make sure belt is in all pulley groo
