ملخص المحتوى في الصفحة رقم 1
IMPORTANT MANUAL Do Not Throw Away
03076
OPERATOR'S MANUAL
WARNING:
MODEL:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so can
re sult in serious in ju ry.
PB195H42LT
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
430094 Rev. 1 08.19.09 AP Printed in the U.S.A.
ملخص المحتوى في الصفحة رقم 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, discharge guard, or other safety devices in place and WARNING: In order to prevent ac ci - working. den tal starting when setting up, trans- • Slow down before turning. port ing, ad just ing
ملخص المحتوى في الصفحة رقم 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to • Never operate machine in a closed area. • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. • Never tamper with safety devices. Check their proper children will remain where you last saw them. • Kee
ملخص المحتوى في الصفحة رقم 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give you the best possible dependability and performance. Gasoline Capacity 1.50 Gallons and Type: Unleaded Regular Should you experience any problem you cannot easily rem- edy, please contact your nearest authorized service center/ Oil Type (API-SG-SL): SAE 30 (above 32°F) department. We have com pe tent, well-trained tech ni cians SAE 5W-30 (below 32°F)
ملخص المحتوى في الصفحة رقم 5
UNASSEMBLED PARTS Steering Wheel (1) Lock Washer Steering (1) Large Wheel Insert Flat Washer Steering Wheel Steering (1) Hex Bolt Extension Shaft Steering Boot Steering Wheel Adapter Seat (1) Washer (1) Seat (1) Hex Bolt Slope Sheet (1) Oil Drain Tube For Future Use Key(s) 5
ملخص المحتوى في الصفحة رقم 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness. INSTALL STEERING WHEEL TOOLS REQUIRED FOR ASSEMBLY • Position front wheels of the tractor so they are pointing A socket wrench set will make assembly easier. Stan dard straight forward
ملخص المحتوى في الصفحة رقم 7
ASSEMBLY • Connect switch to seat. CHECK FOR PROPER POSITION OF BELTS • Place seat on seat pan so all three (3) bottom pads See the figures that are shown for replacing motion and are positioned over large slotted holes in pan. mower blade drive belts in the Service and Adjustments sec- • Push down on seat to engage pads in slots and pull tion of this manual. V erify that the belts are routed correctly. seat towards rear of tractor. CHECK BRAKE SYSTEM • Raise seat and tighten bolt securely.
ملخص المحتوى في الصفحة رقم 8
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST REVERSE NEUTRAL HIGH LOW SLOW CHOKE IGNITION SWITCH P ENGINE START ENGINE OFF REVERSE ENGINE ON PARKING BRAKE PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) FUEL OIL PRESSURE BATTERY REVERSE FORWARD OVER TEMP MOWER HEIGHT MOWER LIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPE HAZARDS DANGER, KEEP HANDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH
ملخص المحتوى في الصفحة رقم 9
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. R ROS "ON" OS "ON" P POSITION OSITION LIGHT SWITCH LIGHT SWITCH THROTTLE/CHOKE THROTTLE/CHOKE CONTROL CONTROL A AT TT TA ACHMENT CHMENT CL CLUTCH/BRAKE UTCH/BRAKE CL CLUTCH LEVER UTCH LEVER PEDAL PEDAL IGNITION IGNITION P PA ARKING
ملخص المحتوى في الصفحة رقم 10
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spec- tacles or stan dard safety glasses. • Never use choke to stop engine. HOW TO USE YOUR TRACTOR IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO
ملخص المحتوى في الصفحة رقم 11
OPERATION TO ADJUST MOWER CUT TING HEIGHT REVERSE OPERATION SYSTEM (ROS) (See Fig. 10) Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse The po si tion of the at tach ment lift le ver (A) de ter mines the direction with the attachment clutch engaged will shut off the cut ting height. engine unless ignition key is placed in the ROS "ON" position. WARNING: Backing up with the attachment clutch en- gaged while mowing is strong
ملخص المحتوى في الصفحة رقم 12
OPERATION • Check engine oil with tractor on level ground. TO OPERATE ON HILLS • Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, CAUTION: Do not drive up or down hills with slopes greater than 15° and remove and read oil level. If necessary, add oil until do not drive across any slope. “FULL” mark on dipstick is reached. Do not overfill. • For cold weather operation you should change oil for • Choose the lowest speed be
ملخص المحتوى في الصفحة رقم 13
OPERATION 5. Move motion control lever to neutral position. Shut- off WARM WEATHER STARTING (50°F (10°C) and above) engine and set parking brake. • When engine starts, move the throttle control to the fast position. 6. Engage transmission by placing freewheel control in engaged position (See “TO TRANSPORT” in this sec- • The attachments and ground drive can now be used. If tion of manual). the engine does not accept the load, restart the engine and allow it to warm up for one minute using
ملخص المحتوى في الصفحة رقم 14
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil
ملخص المحتوى في الصفحة رقم 15
02545 MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any main- bent or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade ap- If tractor requires more than five (5) feet to stop at highest proved by the manufacturer of your tractor. Using a blade not approved by the manu- speed in high est gear on a level, dry concrete or paved facturer of your tractor is hazardous, could
ملخص المحتوى في الصفحة رقم 16
MAINTENANCE V-BELTS TO CHANGE ENGINE OIL (See Figs. 18 and 19) Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not Determine temperature range expected before oil change. ad just able. Re place belts if they begin to slip from wear. All oil must meet API service classification SG-SL. • Be sure tractor is on level surface. TRANSAXLE MAINTENANCE • Oil will drain more freely when warm. The transmission fan and cooling fins should b
ملخص المحتوى في الصفحة رقم 17
00667 MAINTENANCE ENGINE COOLING SYSTEM (See Fig. 20) CLEANING • Clean engine, battery, seat, finish, etc. of all foreign Debris may clog the engine's air cooling system. Remove blower housing and clean the area shown to prevent over- matter. heating and engine damage. • Clean debris from steering plate. Debris can restrict clutch/brake pedal shaft movement, causing belt slip and loss of drive. AIR SCREEN CLEAN OUT CHAFF AND DEBRIS CAUTION: Avoid all pinch points and movable parts (See Fi
ملخص المحتوى في الصفحة رقم 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress brake pedal fully and set parking brake. • Place motion control lever in neutral position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN ATTA
ملخص المحتوى في الصفحة رقم 19
SERVICE AND ADJUSTMENTS • Insert end of link (E) into hole in front mower bracket • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO and secure with washer and retainer spring (J). CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 26 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 24 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS
ملخص المحتوى في الصفحة رقم 20
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Figs. 31 & 32) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 29) IMPORTANT:
