ملخص المحتوى في الصفحة رقم 1
03002
YTH1848XPT
Owner's Manual
ملخص المحتوى في الصفحة رقم 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and cidental starting when setting up, working. transport ing, ad justing or making re- • Slow down bef
ملخص المحتوى في الصفحة رقم 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to • Never operate machine in a closed area. • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. • Never tamper with safety devices. Check their proper children will remain where you last saw th
ملخص المحتوى في الصفحة رقم 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES Gasoline Capacity 4 Gallons • Read and observe the safety rules. and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for Oil Type (API-SG-SL): SAE 30 (above 32°F) and using your tractor. SAE 5W-30 (below 32°F) • Follow the instructions under “Maintenance” and “Stor- Oil Capacity: W/ Filter: 3.8 Pints age” sec tions of this own er’s manual. W/O Filter: 3.2 Pints Spark Plug: Champion RCJ8Y (Gap: .040")
ملخص المحتوى في الصفحة رقم 5
UNASSEMBLED PARTS Slope Sheet Key (1) Oil Drain Tube (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed. (1) 3/4" wr
ملخص المحتوى في الصفحة رقم 6
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. CHECK FOR PROPER POSITION OF ALL Follow the ap pro pri ate instruction below to remove the BELTS tractor from the skid. See the fi gures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments W ARNING: Before start ing, read, un der stand and fol low sec tion of this manual. Verify that the belts are routed all in struc tions in the Op er a tion section of this manu al. Be correc
ملخص المحتوى في الصفحة رقم 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF REVERSE OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON BATTERY CRUISE CONTROL FUEL REVERSE FORWARD PEDAL 15 15 ATTACHMENT DANGER, KEEP HANDS ATTACHMENT SLOPE HAZARDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFE
ملخص المحتوى في الصفحة رقم 8
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. P H D E G K L N B F J Q C A M FIG. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER – Used to raise and lower the (H) LIGHT SWITCH – Turns the headligh
ملخص المحتوى في الصفحة رقم 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while op- erating your tractor or per form ing any adjustments or repairs. We rec ommend a wide vision safety mask over spectacles or stan dard safety glasses. IMPORTANT: Leaving the ignition switch in any position HOW TO USE YOUR TRAC TOR other than "STOP" will cause the battery to discharge and go dead. TO SET PARK
ملخص المحتوى في الصفحة رقم 10
OPERATION SYSTEM CHARACTERISTICS NOTE: Adjust gauge wheels with tractor on a fl at level surface. The cruise control should only be used while mowing or • Adjust mower to desired cutting height (See “TO AD- transporting on relatively smooth, straight surfaces. Other JUST MO WER CUT TING HEIGHT” in this sec tion of con di tions such as trimming at slow speeds may cause the manual). cruise control to dis en gage. Do not use the cruise control on slopes, rough terrian or while trimmimg or t
ملخص المحتوى في الصفحة رقم 11
OPERATION NOTE: To protect hood from damage when transporting WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator hood to tractor (rope, cord, etc.). decides it is necessary to reposition the machine with the
ملخص المحتوى في الصفحة رقم 12
OPERATION COLD WEATHER STARTING ( 50° F and below) ADD GASOLINE • When engine starts, allow engine to run with the throttle • Fill fuel tank to bottom of fi ller neck. Do not overfi ll. Use control in the choke position until the engine runs roughly, fresh, clean, regular un lead ed gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon then move throttle control to fast position. This may re- and lead oxide deposits and reduce valve life). Do not quire a
ملخص المحتوى في الصفحة رقم 13
OPERATION • Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. Disengage parking brake. • Drive tractor forward for approximately fi ve feet then backwards for fi ve feet. Repeat this driving procedure three times. Your transmission is now purged and now ready for normal op er a tion. MOWING TIPS • Mower should be properly leveled for best mowing per- FIG. 12 formance. See “TO LEVEL MOWER HOUSING” in the Service and A
ملخص المحتوى في الصفحة رقم 14
maint_sch-tractore.ROS.e MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1
ملخص المحتوى في الصفحة رقم 15
02544 MAINTENANCE BLADE CARE TRACTOR For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- worn, bent or damaged blades. te nance. CAUTION: Use only a replacement blade BRAKE OPERATION approved by the manufacturer of your If tractor requires more than fi ve (5) feet to stop at highest tractor. Using a blade not approved speed in high est gear on a level, dry concrete or paved by the manufacturer of your tractor is surface, then bra
ملخص المحتوى في الصفحة رقم 16
MAINTENANCE • Rinse the battery with plain water and dry. TO CHANGE ENGINE OIL (See Figs. 14 and 15) • Clean terminals and battery cable ends with wire brush Determine temperature range expected before oil change. until bright. All oil must meet API service classifi cation SG-SL. • Coat terminals with grease or petroleum jelly. • Be sure tractor is on level surface. • Reinstall battery (See “REPLACING BATTERY" in • Oil will drain more freely when warm. the SERVICE AND ADJUS
ملخص المحتوى في الصفحة رقم 17
MAINTENANCE ENGINE OIL FILTER CLAMP CLAMP Replace the engine oil fi lter every season or every other oil change if the tractor is used more than 100 hours in one year. FUEL FILTER MUFFLER FIG. 16 Inspect and replace corroded muffl er and spark arrester (if equipped) as it could create a fi re hazard and/or dam- age. CLEANING • Clean engine, battery, seat, fi nish, etc. of all foreign SPARK PLUGS matter. Replace spark plugs at the beginning of each mowing • Keep fi nished surfaces and whee
ملخص المحتوى في الصفحة رقم 18
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR AD JUST - MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. • From right side of mower, disconnect anti-sway bar (S) TRACT
ملخص المحتوى في الصفحة رقم 19
SERVICE AND ADJUSTMENTS A B 02965 FIG. 20 • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer spring. • Repeat on opposite side of tractor. A C 02965 NOTE: Be sure mower side suspension arms (A) are pointing D forward before sliding mower under tractor. • Slide mower under tractor until it is centered under tractor. • FIRST INSTALL ANTI-SWAY BAR (S). - From right side of mower,
ملخص المحتوى في الصفحة رقم 20
SERVICE AND ADJUSTMENTS • Disengage belt tension rod (K) from locking bracket TO LEVEL MOWER (L). Make sure tires are properly infl ated to the PSI shown on • Install belt onto engine clutch pulley (M). tires. If tires are over or under infl ated, it may affect the IMPORTANT: Check belt for proper routing in all mower appearance of your lawn and lead you to think the mower pulley grooves. is not adjusted properly. VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 25) • With all tires prope
