ملخص المحتوى في الصفحة رقم 1
917.289610
(YTH2042)
Owner's Manual
532 43 65-48
ملخص المحتوى في الصفحة رقم 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, discharge chute, or other safety devices in place and WARNING: In order to prevent ac ci - working. den tal starting when setting up, trans- • Slow down before turning. port ing, ad just ing or
ملخص المحتوى في الصفحة رقم 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers GENERAL III. CHILDREN • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to is in safe working condition. the ma chine and the mowing activity. Never assume that • Never tamper with safety devices. Check their proper children will remain where you last saw them. operation reg
ملخص المحتوى في الصفحة رقم 4
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 2.5 Gallons • Follow a regular schedule in maintaining, caring for and Type: Unleaded Regular and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) • Follow the instructions under “Maintenace” and “Stor- SAE 5W-30 (below 32°F) age” sec tions of this own er’s manual. Oil Capacity: W/Filter: 56 oz. WARNING: This tractor is equipped with an internal com- W/O Filter: 48 oz.
ملخص المحتوى في الصفحة رقم 5
UNASSEMBLED PARTS Keys Slope Sheet (1) Oil Drain Tube For Future Use (2) Keys ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. TOOLS REQUIRED FOR ASSEMBLY ADJUST SEAT (See Fig. 2) A socket wrench set will make assembly easier. Stan dard • Sit in seat. wrench sizes are listed. • Lift up adjustment lever (A) and slide seat until a com- (1) 1/2" wrench Tire pressure gauge fortable position is reached which allows
ملخص المحتوى في الصفحة رقم 6
ASSEMBLY CHECK TIRE PRESSURE ✓CHECKLIST The tires on your tractor were overinflated at the factory BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE for shipping purposes. Correct tire pressure is important WISH TO ASSURE THAT YOU RECEIVE THE BEST for best cutting performance. PERFORMANCE AND SATISFACTION FROM THIS • Reduce tire pressure to PSI shown on tires. QUALITY PRODUCT. PLEASE REVIEW THE FOLLOWING CHECKLIST: CHECK DECK LEVELNESS ✓ All assembly instructions have been com plet ed. For best cutt
ملخص المحتوى في الصفحة رقم 7
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH REVERSE ENGINE ON ENGINE START PARKING BRAKE MOWER HEIGHT MOWER LIFT ENGINE OFF OPERATION SYSTEM (ROS) CLUTCH/BRAKE LIGHTS ON FUEL BATTERY REVERSE FORWARD CRUISE CONTROL PEDAL 15 15 ATTACHMENT ATTACHMENT DANGER, KEEP HANDS KEEP AREA CLEAR SLOPE HAZARDS CLUTCH DISENGAGED CLUTCH ENGAGED AND FEET AWAY (SEE SAFET
ملخص المحتوى في الصفحة رقم 8
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. H D G E B A F C M J Fig. 3 Our tractors conform to the applicable safety standards of the American National Standards Institute. (A) ATTACHMENT LIFT LEVER - Used to raise, lower, (F) IGNITION SWITCH - Used for starting and stopping
ملخص المحتوى في الصفحة رقم 9
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. • Turn ignition key (F) to “STOP” position and remove HOW TO USE YOUR TRACTOR key. Always remove key when leaving tractor to prevent un au tho rized use. TO SET
ملخص المحتوى في الصفحة رقم 10
OPERATION TO ADJUST MOWER CUTTING HEIGHT TO OPERATE MOWER (See Fig. 8) Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with The position of the attachment lift lever (A) determines the the engine running and the attachment clutch engaged will cutting height. shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitat- ing or cutting off when operating your equipment on ro
ملخص المحتوى في الصفحة رقم 11
OPERATION TOWING CARTS & OTHER ATT ACH MENTS BEFORE STARTING THE ENGINE Tow only the attachments that are recommended by and CHECK ENGINE OIL LEVEL comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, The engine in your tractor has been shipped, from the while on a slope, is dangerous. Tires can lose traction with factory, already filled with sum mer weight oil. the ground and cause you to lose control of your tractor. • Chec
ملخص المحتوى في الصفحة رقم 12
OPERATION • Insert key into ignition and turn key clockwise to “START” CAUTION: At any time, during step 4, there position and release key as soon as engine starts. may be movement of the drive wheels. Do not run starter continuously for more than fifteen sec onds per minute. If the engine does not start after 4. Move motion control lever to full forward position and several attempts, move throttle control to fast position, hold for five (5) seconds. Move lever to full reverse wait a fe
ملخص المحتوى في الصفحة رقم 13
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH 8 25 50 100 SEASON STORAGE SCHEDULE USE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure T Check Operator Presence & ROS Systems R Check for Loose Fasteners A Check/Replace Mower Blades 3 C T Lubrication Chart 0 Check Battery Level 4 R Clean Battery and Terminals Clean Debris Off Steering Plate 5 Check Transaxle Cooling Check Mower Levelness Check V-Belts Check Engine Oil Level Change Engine Oil (with oil
ملخص المحتوى في الصفحة رقم 14
MAINTENANCE TRACTOR CAUTION: Use only a replacement blade ap- Always observe safety rules when per form ing any proved by the manufacturer of your tractor. main te nance. Using a blade not approved by the manu- facturer of your tractor is hazardous, could BRAKE OPERATION damage your tractor and void your warranty. If tractor requires more than five (5) feet to stop at highest BLADE REMOVAL (See Fig. 15) speed in high est gear on a level, dry concrete or paved surface, then brake must be che
ملخص المحتوى في الصفحة رقم 15
MAINTENANCE OIL DRAIN VALVE TRANSAXLE MAINTENANCE The transmission fan and cooling fins should be kept clean CLOSED to assure proper cooling. AND LOCKED Do not attempt to clean fan or transmission while engine POSITION is running or while the transmission is hot. To prevent pos - si ble damage to seals, do not use high pressure water or DRAIN steam to clean transmission. YEL LOW CAP TUBE • Inspect cooling fan to be sure fan blades are intact and clean. Fig. 16 • Inspect cooling fins for
ملخص المحتوى في الصفحة رقم 16
00667 MAINTENANCE IN-LINE FUEL FILTER (See Fig. 18) DECK WASHOUT PORT (See Fig. 20) The fuel filter should be replaced once each season. If fuel Your tractor’s deck is equipped with a washout port on filter becomes clogged, ob struct ing fuel flow to car bu re tor, its surface as part of its deck wash system. It should be re place ment is re quired. utilized after each use. 1. Drive the tractor to a level, clear spot on your lawn, near • With engine cool, remove filter and plug fuel line s
ملخص المحتوى في الصفحة رقم 17
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress brake pedal fully and set parking brake. • Place motion control lever in neutral position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTANT: IF AN ATTA
ملخص المحتوى في الصفحة رقم 18
SERVICE AND ADJUSTMENTS • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO • Insert end of link (E) into hole in front mower bracket CHASSIS - Position hole in arm over pin (B) on outside and secure with washer and retainer spring (J). of tractor chassis and secure with retainer spring. E • Repeat on opposite side of tractor. A J F H B Fig. 24 • Hook end of clutch cable spring (Q) into hole in idler arm (R). Fig. 22 • Push clutch cable housing guide (P) into bracket, slide • ATTACH REAR LIFT LINKS (C
ملخص المحتوى في الصفحة رقم 19
SERVICE AND ADJUSTMENTS • If adjustment is necessary, see step in Visual Adjust- TO LEVEL MOWER ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal. appearance of your lawn and lead you to think the mower is not adjusted properly. FRONT-TO-BACK ADJUSTMENT (See Fig. 29 & 30) VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 27) IMPORTANT: D
ملخص المحتوى في الصفحة رقم 20
SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT TO REPLACE MOTION DRIVE BELT (See Fig. 31) (See Fig. 32) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. En gage parking brake. Park the tractor on level surface. Engage parking brake. For as sis tance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL - BELT REMOVAL - • Remove mower from tractor (See “TO REMOVE MOW ER” in this section of manual). • Re
