Dixon ZTR 428 D 429 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TECHNICAL DATA BROCHURE - ZTR 428 d 429 Page 1
IMPORTANT - READ OPERATOR'S MANUAL BEFORE OPERATING OR MAKING ADJUSTMENTS
Deluxe Seat Adjustment
Easy hand lever action allows forward and backward movement of seat. No bolts to loosen or
tighten.
Mower Blade Operation
1. To start mower blades, pull up slightly on blade drive switch handle and move it
forward to the "ON" position. 2. To stop mower blades, move switch
handle to the "OFF" position.

ملخص المحتوى في الصفحة رقم 2

ملخص المحتوى في الصفحة رقم 3

ملخص المحتوى في الصفحة رقم 4

ملخص المحتوى في الصفحة رقم 5

ملخص المحتوى في الصفحة رقم 6

ملخص المحتوى في الصفحة رقم 7

v~ \

ملخص المحتوى في الصفحة رقم 8

ملخص المحتوى في الصفحة رقم 9

THE FOLLOWING INSTRUCTION REFER TO 1989 PTOFUVYION 42” MOERT FRVKD Installation: 1. Position mower deck assembly under frame, raise front of mower deck assembly enough to allow cross shaft (P/N 1332) to slide through frame guides and mower deck guides. Install (1) washer (P/N 3094) and (1) hair pin cotter (P/N 3072) on each end of the cross shaft. 2. Attach short L-rod (P/N 1355) to lift a

ملخص المحتوى في الصفحة رقم 10

Page 10 4. Note: It is possible to install the engine to mower deck drive belt CP/N 6111) at this time; however, our engine manufacturers have suggested that this belt be installed after the engine has been fully serviced per manufacturers' suggestions and allowed to operate at 1/2 to 3/4 throttle settings for approximately C3) minutes. This will place the initial start up of the engine in a no load situation and allow complete