Anton/Bauer ElipZ 10K دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TM
®
The worldwide standard
®
sm
The power behind the best cameras capturing the best images in the world.
FULLY READ ALL INSTRUCTIONS BEFORE USE
ATTACH BATTERY TO CAMERA
(1) Charge battery fully (see “CHARGING” section)
(2) Remove shoe mount from battery
(3) Attach shoe to bottom of camera – tighten securely
(4) Pull back on battery slide lock
(5) Attach battery to shoe mount on bottom of camera, release slide lock
(6) Connect faux battery end of camera cable to camer

ملخص المحتوى في الصفحة رقم 2

Charging Battery (1) Remove ELIPZ cable from battery if attached to camera. (2) Remove battery from camera. (3) Attach charger to AC mains source (100-240 VAC 50-60 Hz). Blue LED should light on charger (If blue LED does not light, check mains source). (4) Attach ELIPZ connector from charger to battery. (5) Red light on charger will begin to flash within 10 seconds. This means the battery is charging. (6) Red light will go out (approximately 4 hours) and Green LED will flash. Battery