ملخص المحتوى في الصفحة رقم 1
User's Guide
Black-and-White Raster Plotter
LP-1020
LP-1020L
Read this User's Guide to use the plotter safely and
properly. Keep this manual in a place where you
can quickly access it at any time.
Seiko I Infotech Inc.
ملخص المحتوى في الصفحة رقم 2
ملخص المحتوى في الصفحة رقم 3
U00107742300 November 2007 U00107742301 December 2007 ©Seiko I Infotech 2007 Reprinting of this manual without permission is prohibited. The content of this manual may be changed without notice. D-SCAN is a registered trademark of Seiko Instruments, Inc. Ethernet is a registered trademark of Xerox, Inc. HP is a registered trademark of Hewlett-Packard (U.S.A.) MICRO CADAM is a trademark of CADAM, Inc. (U.S.A.) Athlon is a trademark of Advanced Micro Device, Inc. Intel, Pentium and Core are regis
ملخص المحتوى في الصفحة رقم 4
CE Marking It is legally mandatory for products distributed or sold in the EU to bear a CE Mark that indicates compliance with requirements set forth in EC directives for the particular product. These directives set the scope of machinery subjected to the specific directive. Our LP-1020 complies with the EMC Directive (2004/108/EC) and Low Voltage Directive (2006/95/EC). For inquiries concerning CE Marks: Seiko Instruments Europe S.A European Head Office Avenue de Messidor 198, 1180, Brussels, B
ملخص المحتوى في الصفحة رقم 5
Introduction Thank you for purchasing our LP-1020/1020L Black-and-White Raster Plotter (hereafter referred to as “this device”). This manual explains the overall device operations, functions and operation method under the premise that installation of the device has been completed. Before using this device, please read the “Safety Precautions” so that you may operate this device safely and correctly. Keep this manual in a place where you can quickly access it at any time. This device employs eith
ملخص المحتوى في الصفحة رقم 6
Safety Precautions The following symbols are used in this manual to ensure the proper use of the plotter and to prevent the plotter from being damaged. Please follow these guidelines: Warnings must be followed carefully to avoid serious WARNING bodily injury or death. Cautions must be observed to avoid damage to your CAUTION equipment and bodily injury. Example of symbols: This symbol ( ) denotes items that require special care while executing a certain procedure or operation. This symbol ( ) de
ملخص المحتوى في الصفحة رقم 7
Warning DO NOT touch any of the parts inside the plotter with a "HIGH VOLTAGE" label attached as it may result in electric shock. DO NOT touch any of the parts inside the plotter with a "HIGH TEMPERATURE" label attached as it may result in severe burns. DO NOT disassemble or modify the plotter. DO NOT repair the plotter by yourself. Doing so may cause fire, electric shock or other accidents. DO NOT throw the toner cartridge or waste toner bottle into fire or place them near heat as they could ex
ملخص المحتوى في الصفحة رقم 8
Caution DO NOT disassemble, modify the toner cartridge. If toner gets on your skin or clothes, wash off the affected area immediately with soap and water. Handle the toner cartridge with extreme care. Should any toner get into your eyes, do not rub them, flush them immediately with water, and see a physician immediately. Handle the paper rolls with care because they are very heavy. Dropping them may lead to personal injury. Use care when cutting the paper rolls with a scissors or knife during in
ملخص المحتوى في الصفحة رقم 9
Warning labels Warning labels are affixed to this device at the locations indicated in the diagram below. You should understand the meanings of these warning labels and handling instructions. 3 “WARNING: HIGH VOLTAGE” label 2a “Caution when dealing with paper jam” label 1 “Caution: high temperature” label 2b “Caution when dealing with paper jam” label v
ملخص المحتوى في الصفحة رقم 10
1 “Caution: high temperature” label (It is affixed to the inside of the fixation door.) This label cautions you not touch this area due to high temperature. The fixation device will become hot. Take care to avoid contact when dealing with paper jams. 2 “Caution when dealing with paper jams” label This label indicates the direction that jammed paper should be pulled out when paper is jammed in the fixation device. Follow the directions on the label to remove the paper. a b 3 “WARNING: HIGH VOLTAG
ملخص المحتوى في الصفحة رقم 11
How to read this manual Manual make-up This manual is composed of 13 chapters and an appendix. Chapter 1 provides information that you should know before using this device, such as device features and part names. First read chapter 1 for an understanding of basic matters pertaining to this device. Chapter 2 provides information on matters you will need to know to operate this device, such as turning the power on and off, and how to put paper in the device. Refer to this chapter for basic informa
ملخص المحتوى في الصفحة رقم 12
Notation method Markings Warning ◆ This mark indicates warnings that must be followed carefully to avoid serious bodily injury or death. Caution ◆ This mark indicates cautions that must be observed to avoid damage to the equipment and bodily injury. Note ◆ Contain important information. This is a “Tip” mark. Contain additional hints for better use. ⇒ This is a “See” mark. A reference section and page is indicated after this mark. DSCAN format Please remember: The DSCAN format described in this m
ملخص المحتوى في الصفحة رقم 13
Key/LCD/LED notations Indicates a control Indicates the control panel key. panel LCD. 1 Press to proceed to the ME NU menu screen where settings #SETUP are managed. SE TUP 2 Press and select “SETUP.” #PORT 1 _HPGL 3 Press or and select SE TUP “PORT2_HPGL.” #PORT 2 _ HPGL Indicates flashing light LED on, flashing, and off states are indicated as follows: On Flashing Off ix
ملخص المحتوى في الصفحة رقم 14
Supplied components Components and options listed below are included. If any components are missing or broken, contact your retailer or your nearest service center. Item Quantity Remarks Plotter unit 1 unit For checking at the time of Toner cartridge 3 units installation Waste bottle 1 unit Pre-installed Quick Reference Guide 1 or 2 copies 200V: English and Chinese CD-ROM 1 set Paper flange 2 units/drawer Process cartridge 1 unit With 2 ozone filters A0, A1, A3 x 1 unit each, for Roll paper 1 bo
ملخص المحتوى في الصفحة رقم 15
TABLE OF CONTENTS Introduction .......................................................................................... i Safety Precautions.............................................................................. ii Warning labels .................................................................................... v How to read this manual ................................................................... vii Manual make-up ...............................................................
ملخص المحتوى في الصفحة رقم 16
Chapter 2 Basic operations 2-1 Plotting procedures overview...........................................................2-3 Turning the power on and off ...........................................................2-3 Power on .............................................................................2-4 Power off .............................................................................2-6 Installation operations ......................................................................2-7 Online
ملخص المحتوى في الصفحة رقم 17
Manual paper feeding (cut paper)..................................................2-34 Manual feeding procedures ...............................................2-34 Manual paper feeding procedure ......................................2-35 Pause, continue, cancel (and additional printing) ..........................2-39 Print stop ...........................................................................2-39 Continue printing ...............................................................2-39 Can
ملخص المحتوى في الصفحة رقم 18
Jobs .................................................................................................3-4 Reprinting ............................................................................3-4 Settings menu ..................................................................................3-5 PDL menu ........................................................................................3-8 When using our company’s printer driver ............................3-8 Items which you can set ......
ملخص المحتوى في الصفحة رقم 19
Chapter 5 "SETUP" Menu 5-1 Setting parameter items................................................................... 5-2 Setup menu setting parameter table ................................... 5-3 Setup parameter priority mode .......................................... 5-10 PARAMETER MODE (DSCAN only) ................................. 5-11 MEDIA SERIES (HP-GL, TIFF, CALS only) ...................... 5-11 AUTO SUPPLY ................................................................. 5-12 FIXING MO
ملخص المحتوى في الصفحة رقم 20
Chapter 7 "PAPER" menu 7-1 Setting items .................................................................................... 7-2 MEDIA TYPE ....................................................................... 7-2 MEDIA SERIES ................................................................... 7-3 Chapter 8 "FUNCTION" menu 8-1 Setting items .................................................................................... 8-2 MENU PRINT ......................................................
