American Standard Enfield 2373.401 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation
Instructions
ENFIELD
2373.401
BIDET FITTING
2373.421
and VACUUM BREAKER
with EverClean™ Finish
Congratulations on purchasing your American Standard faucet
with EverClean finish found only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
Certified to comply with ASME A112.18.1M
• Eliminates the need for cleaners and scrubbing U.S. Patent No. 5,819,789
• Permanent surface protectant remains beautiful
for the life of the faucet
• EverClean™ ava

ملخص المحتوى في الصفحة رقم 2

DRAIN INSTALLATION SPRAY INSTALLATION Assemble SPRAY BODY (1) to BIDET. Using putty, seal Assemble O-RING (1), WASHER (2), PIVOT underside of SPRAY BODY FLANGE (2) and secure with ROD (3) and NUT (4) to DRAIN BODY (5). NUT (3). Concave side of cup WASHER (2) is toward ball. Screw SPRAY HOSE (4) with SEAL WASHER (5) to SPRAY BODY (1). Connect other end of HOSE (4) with SEAL Thread LOCKNUT (6), WASHER (7) and WASHER (6) to side outlet NIPPLE (7) of the TRANSFER GASKET (8) onto DRAIN BODY (5). VA

ملخص المحتوى في الصفحة رقم 3

INSTALL HANDLES DIVERTER KNOB: Install HANDLE ADAPTER (8) onto valve stem. Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) without a spline is facing up. See figure "A". Tighten STEM SCREW (3) to secure ADAPTER (1). Push DIVERTER KNOB (7) onto HANDLE ADAPTER (8). Find correct position of LEVER HANDLE ASSEMBLY (4) or CROSS Install RING (9) onto DIVERTER KNOB (7) and tighten HANDE ASSEMBLY (5) by adjusting male teeth on ADAPTER (1) to with HANDLE SCREW (10). female teeth in

ملخص المحتوى في الصفحة رقم 4

TEST INSTALLED FITTING 1 With HANDLES (1) in OFF position, turn on WATER 6 SUPPLIES (2) and check all connections for leaks. Operate both handles to flush water lines thoroughly. 3 Turn DIVERTER (6) to rim wash and bidet spray. Operate Lift Rod (3) and fill Bidet with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Bidet. Adjust stopper height by repositioning Lift Rod (3) and tightening Thumbscrew (5). Release DRAIN STOPPER (4) and check all drain connections for leaks