American Standard Deck-Mount Bath Filler 2980 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation
Instructions
THE
“”
2980
™ DECK-MOUNT
COLLECTION
by
BATH FILLER
2981
Thank you for selecting American-Standard...the
benchmark of fine quality for over 100 years.
Certified to comply with ANSI A112.18.1M
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
M968212
Required Tools
ROUGHING-IN DIMENSIONS
ADJ. 6-1/2 TO 12
Flat Blade Screwdriver
7-1/4
4-1/4"
2-1/2D. 2-1/16
3-1/2"
D.
2-7/8"
MOUNTING
2-1/2D.
SURFACE
*Wrench
1-1/4
1

ملخص المحتوى في الصفحة رقم 2

VALVE ASSEMBLY 3 Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks. 9 MOUNTING 11 Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4) SURFACE into mounting holes from underside of ledge. 10 Press TEE (5) onto SPOUT SHANK (6) making certain that the O-RING (7) is properly seated on SHANK (6). Push COUPLING (8) into TEE (5) and attach to SPOUT SHANK (6) and tighten. Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING 9 SURFACE (11). If necessary, ad

ملخص المحتوى في الصفحة رقم 3

HANDSHOWER INSTALLATION (Model 2981 series only) 6 Check with local codes, and if required, add a vacuum breaker IMPORTANT kit (part no. 028708) at specified height. Refer to the install- lation instructions supplied with the kit. 11 Drop SPRAY ESCUTCHEON (1) through the fourth hole of the tub ledge (12" max from SPOUT center) with SPRAY ESCUTCHEON (1) directed towards tub center. Be sure RUBBER RING (2) is properly seated in ESCUTCHEON (1). Install RUBBER WASHER (3) and LOCKNUT (4} from 9 und