Lightolier Lighting Systems IS-EG2 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Lighting Systems IS-EG2













10”

We reserve the right to change details of design, materials and finish.
B0608

ملخص المحتوى في الصفحة رقم 2

Lighting Systems IS-EG2 48” or 96” 48” or 96” Junction Box (By Others) Canopy Canopy Power Canopy Figure 1 Power Cord #8 Screws Cover Male Plug 1/4-20 Bolt Cable Gripper Power Cord Female Plug Figure 2 Screw End-Cap (Do Not Over Tighten) 1/4-20 Bolt We reserve the right to change details of design, materials and finish. B0608

ملخص المحتوى في الصفحة رقم 3

Lighting Systems IS-EG2 Step 1. Installing the Suspension Cables A. Step 2. Installing the First Fixture A. Step 3. Installing the Remaining Fixtures A. F. Step 4. End of Row A. We reserve the right to change details of design, materials and finish. B0608

ملخص المحتوى في الصفحة رقم 4

Lighting Systems IS-EG2 Step 1. Modifying the Unit A. F. NOTE: In some instances some of the wires in the fixture are required to remain uncut. (DALI, SHARING DAYLIGHT SENSOR , ETC.) In this case only cut and tap into the hot and neutral wires in the wire harness. Power Cord 1st Power Drop 2nd Power Drop 96" 96" 96" 96" 96" 48" Figure 3 We reserve the right to change details of design, materials and finish. B0608