Lightolier IS:1102P1 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE. INSTRUCTION SHEET NO.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
IS:1102P1
inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
A0403 Page 1 of 2
Retain these instructions for maintenance reference.

ملخص المحتوى في الصفحة رقم 2

INSTRUCTION SHEET NO. INSTALLATION PROCEDURE FOR FRAME-IN KITS IS:1102P1 1002P1 & 1102P1 EXISTING CONSTRUCTION A0403 Page 2 of 2 FIG. A FIG. B FIG. C FIG. D FIG. E FIG. F 1. CUT-OPEN 2. WIRE-IN 3. PUT THRU 4. ANCHOR 5. SNAP-ON 6. PUSH-UP 1. CUT OPENING (FIG. A) Use MOUNTING FRAME opening as template. 2. WIRE-IN (FIG. B) Wire to supply leads. (Use built-In Cable Clamp in J-Box for non- metallic sheathed cable (Romex) or armored cable (BX)). 3. PUT THROUGH (FIG. C) a. Remove ADJUSTABLE MOUNTING B