Ives Offset Intermediate Power Transfer Pivot 7227PT دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation Instructions
7215PT, 7226PT, and 7227PT
3/4”Offset Intermediate Power Transfer Pivot
Left hand
installation shown;
right hand opposite
Right hand Left hand
installation
installation
Frame
leaf
Door leaf
1. Prepare and mortise hinge stile of door and hinge side jamb to receive pivot set. Determine
pivot location using dimensions reverse side. The pivots are handed and must match hand
of door. To determine hand of door and proper pivot position, see diagrams above. Install top
and bo

ملخص المحتوى في الصفحة رقم 2

NOTE ! It is very important for installer to verify that intermediate pivot point lines up with center line of top and bottom pivot points before final installation. Both door and frame pivot leafs located from face of door. Intermediate pivot should be evenly spaced between top and bottom pivots. Heel edge of door must be beveled 1/8” in 2”. Door Leaf Frame Leaf 1-1/16” 9/16” Reference line 27 mm 14 mm Face of C L 3/8” door 7/16” 10 mm 11 mm C L 3/4” 19 mm 3/4” 5/16” 19 mm 8 mm Face of door 5/1