ملخص المحتوى في الصفحة رقم 1
Ergotron LX LCD/Notebook Arm
USA 1-800-888-8458
Europe +31 (0)33-45 45 600
Ergotron LX Ergotron LX Notebook Arm
� 13" (330 mm) height range � 13" (330 mm) height range
� Display tilts +5/-75° forward/back � Display tilts +5/-75° forward/back
� Display pans 180° right/left � Display pans 180° right/left
� Arm pivots 360° � Arm pivots 360°
� Arm extends/retracts display 24" (610 mm) with Extension � Arm extends/retracts display 24" (610 mm) with Extension
� Weight capacity adjusts to hold displa
ملخص المحتوى في الصفحة رقم 2
DETERMINE PLACEMENT OF BASE ON WORK SURFACE. 1 A B Straight Confi guration Corner Confi guration - position base minimum 19" (483mm) from either edge 2 CLAMP OPTION 3 A ATTACH BASE GROMMET G OPTION B 4 888-45-040P-01 rev.H � 10/07 2 of 18
ملخص المحتوى في الصفحة رقم 3
AB A 2 ATTACH BASE - Clamp 1 7/16" i ii EDGE MOUNT (one piece) ) TO OP/B P/BO OT TT TO OM MOUNT (two piece) a a b 7/16" cd b 5 888-45-040P-01 rev.H � 10/07 3 of 18
ملخص المحتوى في الصفحة رقم 4
B 2 ATTACH BASE - Grommet AB C D 1x 1x 1x 1x 1 1x 2x 2 1x 7/16" a bc 7/16" d ef 5 888-45-040P-01 rev.H � 10/07 4 of 18
ملخص المحتوى في الصفحة رقم 5
4 Mount Extension/Arm M NOTE: If attaching Arm directly to pole, without extension skip to Step 4. M Mount Extension/Arm 5 3 Mount Extension/Arm WARNING: * Desk Clamp Installations: The range of motion (side-to-side) for two Extensions/Arms on one pole * mounted with the Desk Clamp option is limited to A B 180º forward (over front of desk clamp base). MOUNT ONE MOUNT TWO EXTENSION/ARM EXTENSIONS/ARMS A A 2x 1 1x 1 180º 1x 2 >180º NOTE: Grommet Mount Insta
ملخص المحتوى في الصفحة رقم 6
4 A B ATTACH DISPLAY ATTACH NOTEBOOK 8 AB C D 4x* 4x* 1x* 1 1x* #8-32 M4 x 10mm 1x* 2 4x* 3/32" 1x* 4mm 1x* For optimum ergonomic viewing, 3 M4 x 10mm set top of monitor screen 1 ″ below eye height of operator. * Quantity per Arm * A ATTACH LABEL A 4 For optimum ergonomic viewing, set top of monitor screen 1 ″ below eye height of operator. 888-45-040P-01 rev.H � 10/07 6 of 18
ملخص المحتوى في الصفحة رقم 7
ATTACH DISPLAY 5 100 x 100mm 75 x 75mm A B 4x aa #8-32 4x M4 x 10 mm b 4x M4 x 10 mm 6 A B ATTACH ARM TO EXTENSION ATTACH ARM TO POLE 12 12 888-45-040P-01 rev.H � 10/07 7 of 18
ملخص المحتوى في الصفحة رقم 8
ATTACH NOTEBOOK B 4 Ergotron's Notebook Tray is designed to attach to Ergotron Arms and Stands with a 75mm x 75mm hole pattern. If you are attaching the Tray to a non-Ergotron product, before proceeding with this installation, you should contact the manufacturer of that mounting solution. NOTE: After you have attached the Ergotron Notebook Tray and your notebook according to these Assembly Instructions, make sure that the Arm/Stand has been adjusted properly to support the weight of bot
ملخص المحتوى في الصفحة رقم 9
5 A B ATTACH ARM TO EXTENSION ATTACH ARM TO POLE 4x M4 x 10 mm 6 ATTACH TRAY a 1x 1x M4 x 8 mm ATTACH PORTRAIT/LANDSCAPE ROTATION STOP SCREW b 2.5mm 12 888-45-040P-01 rev.H � 10/07 9 of 18
ملخص المحتوى في الصفحة رقم 10
7 A B PLACE NOTEBOOK PLACE DOCKING STATION AND NOTEBOOK 11 2x PLACE NOTEBOOK Pads will help prevent notebook from slipping, but they A 7 will not hold all notebooks on the tray in all circum- stances. Use caution while tilting the tray, since some angles may cause the notebook to fall off resulting in equipment damage or personal injury. a 2x b c d 11 888-45-040P-01 rev.H � 10/07 10 of 18
ملخص المحتوى في الصفحة رقم 11
PLACE DOCKING STATION AND NOTEBOOK 3x 2x B 7 e e a bc d 3x f gh i i A ATTACH CLIPS 8 1x 1x b 1x a 12 888-45-040P-01 rev.H � 10/07 11 of 18
ملخص المحتوى في الصفحة رقم 12
ADJUST HEIGHT To change position of Arm on pole, remove Arm from pole, loosen Collar and raise or lower on pole, tighten Collar and replace Arm. 9 Display N No otebook A B ab c d e 2.5mm 2.5mm ROUTE CABLES Leave Slack in cable 10 888-45-040P-01 rev.H � 10/07 12 of 18
ملخص المحتوى في الصفحة رقم 13
LIFT (up and down) a 11 Display Notebook +25˚ +25˚ a 13" 13" (330 mm) (330 mm) -25˚ -25˚ 4mm 11 11 11 RANGE OF MOTION This product is designed to adjust quickly and easily according to your needs – refer to following steps for adjustment. a a Lift – Up and down If it does not stay in place or move- ment is stiff, tension needs adjust- ment. Adjust until motion is equal. Adjust Lift – Up and down To increase tension - Turn Clockwise To decrease tension -
ملخص المحتوى في الصفحة رقم 14
TILT (forward and backward) b - 75˚ Display Notebook +75˚ b -5˚ + 5˚ b Tilt – Forward and Backward b b If it does not stay in place or move- ment is stiff, tension needs adjust- ment. Adjust until motion is equal. Adjust Tilt – Forward and Back- ward To increase tension - Turn Clockwise To decrease tension - Turn Counterclockwise CAUTION DO NOT remove screw. Remov- ing screw may cause damage to equipment. 888-45-040P-01 rev.H � 10/07 14 of 18
ملخص المحتوى في الصفحة رقم 15
SWING (side-to-side) c < 360˚ < 360˚ < 360˚ Display Notebook c < 360˚ 2.5mm C Arm Swing – Side-to-side C C If it does not stay in place or move- ment is stiff, tension needs adjust- ment. Adjust until motion is equal. Adjust Arm Swing – Side-to-side To increase tension - Turn Clockwise To decrease tension - Turn Counterclockwise PORTRAIT/LANDSCAPE d 90˚ 888-45-040P-01 rev.H � 10/07 15 of 18
ملخص المحتوى في الصفحة رقم 16
Troubleshooting ? Symptom Probable Cause Solution Adjust Lift Tension needs adjustment. 13 Display lifts up and down too easily or with diffi culty. Exceeds weight capacity: Ergotron LX: USA 1-800-888-8458 7 - 20 lbs. (3.22 - 9.1 kg). Europe +31 (0)33-45 45 600 Ergotron LX Notebook Arm: 2.5 - 12 lbs. (1.13 - 5.4 kg). Adjust Tilt Display tilts forward and back Tension needs adjustment. 14 too easily or with diffi culty. Adjust Arm Swing Arm swings side-to-side too Tension needs adjustment
ملخص المحتوى في الصفحة رقم 17
? 13 Ergotron LX: USA 1-800-888-8458 5 - 20 lbs. (2.27 - 9.1 kg). Europe +31 (0)33-45 45 600 Ergotron LX 2.5 - 12 lbs. (1.13 - 5.4 kg). 14 15 888-45-040P-01 rev.H � 10/07 17 of 18
ملخص المحتوى في الصفحة رقم 18
888-45-040P-01 rev.H � 10/07 18 of 18
