HP (Hewlett-Packard) HC Netserver LH 3r دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Fan Installation Sheet for HP NetServer LC 3
and LH 3/3r
HP NetServer 550 MHz Upgrade Kit for HP Product Number
D8583A
If you are upgrading from a lower speed processor to a 550 MHz processor on the HP NetServer LC 3 or
LH 3/3r, you must install a new fan to ensure proper cooling. The fan is shipped only for use with the HP
NetServer LC 3 and LH 3/3r.
Use this accessory kit to upgrade the fan in your HP NetServer HP NetServer LC 3 or LH 3/3r, as follows:
• Upgrade an HP NetServer LH

ملخص المحتوى في الصفحة رقم 2

8. To install the new fan, connect the 3-pin connector. Make sure the wires are not crushed. Line up the two slots on the bottom and the one slot on the top of the unit. Line up the screw hole on the top of the fan unit. Support the fan tray with one hand while putting in the screw. Make sure the wires do not obstruct the fan’s airflow. See Figure 1 below. Figure 1. Installing a New Fan 9. To check that the fan is spinning, power up the NetServer and ensure that the fan spins. Pow