Channel Plus CAT CAM 9511BID B&W دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMANCE MULTI-ROOM VIDEO
9500 Series
Models
9511HHR B&W
9511BID B&W
9521HHR Color
9521BID Color
9511PAL B&W
600-129 Rev.B ©1999 Multiplex Technology, Inc., Brea, Ca.
714-996-4100 * 800-999-5225 * fax 714-996-4900 * www.channelplus.com

ملخص المحتوى في الصفحة رقم 2

The CatCam is a surveillance system that creates a new channel to add to existing television channels. The new channel carries a picture from the camera that is placed anywhere in the home. The WARRANTY CatCam was designed to install effortlessly into existing coax home Multiplex Technology, Inc. warrants this product to be free from wiring or into new construction. defects in materials and workmanship for a period of one year from the date of purchase or MTI will repair, or at its option, re

ملخص المحتوى في الصفحة رقم 3

Installation: Step One Specifications: typical @ 25°C ± 5° C Locate the incoming CATV or antenna feed and existing splitter. 9511 (B&W) 9511PAL(AUS) 9521 (Color) (Usually found on the side of the house, in the attic or near the electrical and phone service box) HHR/BID HHR/BID Remove the lock screw located on the bottom of the channel lens viewing angle 78° injector and slide the cover off. Use the mounting ho

ملخص المحتوى في الصفحة رقم 4

Programming a New Channel Installation Step Two The camera mounts using a single gang “J” box. Run a line of Cat 5 Valid channels are 14 thru 64 for UHF and 65 thru 125 for CATV wire from the camera to the channel injector and connect wires as Channels 95-99 are not available. Channels 21 thru 62 are for Pal. shown. prepare the Cat 5 wires by Channel Spacing: stripping 1” of outer sheath and 1/8” of insulation Skip at least one number between the new channel and the closest existing UHF/CATV cha

ملخص المحتوى في الصفحة رقم 5

How to Program Channel Injector wire connection: Determine which unused channel you want to view your video At the channel injector, connect Cat 5 wire as shown. Follow the source on and program the injector for that channel. There must be color coding on the screw terminal. one unused channel both before and after the selected channel to avoid interference. The new channel will be combined with the exist- ing channels and appear on all televisions. When using only quad wire use positions 1, 2,

ملخص المحتوى في الصفحة رقم 6

Method Two: Use the power injector to apply power along the Cat Power Length Requirements 5 or quad wire run. Cut the connecting wire along the run and insert Method One the power injector. Connect the wires using the color coding. Then plug the power supply into the power injector. power injector Up to 300’ of Cat 5 or quad wire maximum for the 9511 B&W. power plug power supply Up to 100’ for the 9521 Color pin 1 blue/white Power Length Requirements Method Two cut Cat 5 wire Up to 100’ of po