X10 Wireless Technology MS18A دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Initializing Motion Detectors If desired, you can specify what zone you want the Motion Detector to be installed
into. Just press the number of the zone you want on the Console’s keypad, before
Remove the cover on the front of the Motion Detector and you press the TEST button on the back of the Motion Detector.
install 2 AA alkaline batteries in the compartment.
Replace the cover to deactivate the tamper switch. Press Clear to back out of the menus. You are asked to confirm, 1. YES, 2 NO.
Press

ملخص المحتوى في الصفحة رقم 2

Battery Replacement Motion Detector If a zone has not reported in during the last four hours, the display will show Model MS18A PROBLEM. This is most likely caused by dead batteries. As long as the batteries have not completely failed they can be replaced with fresh batteries without the need to reinstall the Motion Detector. After removing the old batteries fresh batteries must be fitted within 30 seconds to ensure that the security code is retained. To test the Motion Detector: Once the batter