Honeywell DT7450UK2 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

❶ Select the mounting location. ❷ Separate the sensor housings and remove the printed ❸ Mount the unit.
circuit board (PCB).
Corner
Mount
Wall Mount
Note: The cover
screw, when used,
is installed here.
Wire Channel
Mounting Location Guidelines
• 2.3 m mounting height
• Slide the wire through the wire channel and wire access in
• Avoid direct or reflected sunlight the back housing.
• Use a small screwdriver to unfasten the housing latch. Gently pull apart the
• Aim sensor away from wind

ملخص المحتوى في الصفحة رقم 2

LED INDICATORS DETECTION PATTERNS PRODUCT SPECIFICATIONS Range: Accessories: Top View OPERATION MODE Wide Angle Lens 15 m x 18 m Optional Lens Kit - LED Normal Power Up Fault Zone Finder Long Range Curtain Lens Kit (P/N DT7000-LRLK) Alarm relay: Mounting Brackets - ON Slow Fast OFF Energized Form A Red SMB-10 Swivel Mount Bracket Alarm Blink Blink 30 mA, 24 VDC, (P/N 0-000-110-01) 40 Ohms resistance maximum ON OFF OFF ON Yellow SMB-10T Swivel Mount Bracket w/Tamper Microwave Microwave Tam