Revolabs Inc.VSX7000s دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Revolabs Fusion™ Microphone System- Polycom VSX7000s Setup Guide
NOTES AND CAUTIONS:

This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Polycom VSX7000s video codec.

1. Connecting the Cables
2. Configuring the VSX7000s Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please rea

ملخص المحتوى في الصفحة رقم 2

Connecting the Cables CONNECTING A REVOLABS FUSION MICROPHONE SYSTEM TO POLYCOM VSX7000S VIDEO CODEC 1. Connect a male RCA-RCA audio cable between the “CONF IN” port on the Fusion and the red “AUDIO OUT” port on the VSX7000s. 2. Connect a male RCA-RCA audio cable between the “CONF OUT” port on the Fusion and the red “LINE INPUT” port on the VSX7000s. 3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and the Speakers. Note

ملخص المحتوى في الصفحة رقم 3

Configuring the VSX7000s Video Codec CONFIGURING THE AUDIO MENUS OF THE VSX7000S VIDEO CODEC 1. Select SYSTEM 2. Select ADMIN SETTINGS 3. Select AUDIO 4. Set Red LINE INPUT to AUDIO MIXER 5. DISABLE Echo Canceller 6. DISABLE Polycom microphones by removing checkmark on ENABLE POLYCOM MICROPHONES 7. Set the output volume on the VSX7000s to 100% or “50” in the audio configuration menu. NOTE: You must use your Fusion remote control to control the room volume for both the audio and v