Toyota 250-4235 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

16 V ALVE ENGlNEtrHROTTLE ADAPTOR PACKAGE -250-4235
I. Remove the throttle shaft nut and lock washer from the throttle shaft. Install the Bracket- Throttle Lever
on the throttle shaft. Reinstall the lock washer and hex nut, and torque the nut to 60-72 In/Lbs (5-6Ft./Lbs),
See Figure I.
NOTE: Start nut by hand first to prevent cross threading, DO NOT OVERTIGHTEN HEX NUT .
Throttle Body
Loosen This Nut
~
Pulley Assembly
) l
ONLY
-,\
~
~,\i I-.
IJlj
-.
~
~
-~ -
T
Cable Bracket
Bead Chain
Snap-In Ad

ملخص المحتوى في الصفحة رقم 2

=1 ~ '" '" '" '" "1' - O:s:=:s:f """ Cruise Control Nut and Washer Cable Assembly 114-20 FIGURE 2 .After Tllreading Cable 5. To use that Snap-In adaptor, it will be necessary to fonn threads on the end of the Cruise Control Cable. This is accomplished by placing the 1/4"-20 Nut and Washer Assembly on the end of the Cruise Control Cable with your fingers, t~en use a 7/16"box end wrench and turn clockwise, until the desired amount of threads have been formed as shown in Figure 2. 6. After the thre