ملخص المحتوى في الصفحة رقم 1
PERFORMANCE SERIES
UHF TRUE DIVERSITY SYSTEMS
OWNER’S MANUAL
411UDR • 511DRH
51HT • 51XT • 51BT
AZDEN CORPORATION
147 New Hyde Park Road, P.O. Box 10
Franklin Square, NY 11010
516.328.7500 vox • 516.328.7506 fax
azdenus@azdencorp.com • www.azdencorp.com
ملخص المحتوى في الصفحة رقم 2
Thank you for purchasing AZDEN’S “PERFORMANCE SERIES” wireless system. UHF wireless systems yield a better signal to noise ratio and improved frequency response over VHF systems. The UHF band is less crowded than VHF thus giving you less likelihood of interference. This manual covers the 411UDR and 511DRH receivers and the 51BT, 51XT and 51HT transmitters. Receiver Descriptions: The 411UDR and 511DRH are crystal controlled, PLL synthesized receivers with 63 on-board user selectable frequencies
ملخص المحتوى في الصفحة رقم 3
(5) 12 Volt Input Plug the supplied AC adapter into the 12 volt input on the receiver then into an AC electrical outlet. Use only the adapter supplied, as other adapters may damage the receiver. (6) Output Adjustment Rotate this knob clockwise to increase, or counterclockwise to decrease volume level. (7) Output (unbalanced) Using a suitable audio cable (not supplied) connect the 1/4-inch phone jack end to the audio output on the receiver, and connect the other end of the cable to the suitable
ملخص المحتوى في الصفحة رقم 4
HR-2 The following feature is for the 511DRH only. (12) Squelch adjust This adjusts the point at which the receiver will shut off or “squelch” the incoming radio signal when it becomes too weak. Turning the control clockwise raises the threshold, allowing more signal to enter, and turning the control counterclockwise lowers the threshold, letting in less signal. When operating multiple systems all receivers and transmitters must be on the same group Example: 4 systems operating simultaneously.
ملخص المحتوى في الصفحة رقم 5
Transmitter Descriptions: 51HT Handheld microphone transmitter with 63 on-board user selectable UHF frequencies. Ideal for all vocal applications. (1) To install batteries, turn the bottom half of the mic case counterclockwise until it is completely off. (2) Insert two fresh alkaline “AA” batteries into the compartment. Make sure battery polarity is correct. (3) Frequency select The group knob allows you to select any of seven frequency groups (numbered from 0-6). The channel knob allows you to
ملخص المحتوى في الصفحة رقم 6
3 4 5 6 1 2 The 51BT body-pack transmitter has 63 user selectable UHF frequencies and is ideal for lavaliere and headset microphones. The optional MP-1H instrument cable allows the 51BT to work with electric guitars and basses. (1) Open the battery compartment lid by sliding it down and raising it. (2) Insert one fresh alkaline 9-volt battery into the compartment. Make sure battery polarity is correct. (3) Frequency select: The group knob (left) allows you to select any of seven frequency groups
ملخص المحتوى في الصفحة رقم 7
51XT plug-in XLR transmitter with 63 on-board user selectable UHF frequencies. Ideal for use with dynamic microphones with XLR output. (1) Open the battery compartment lid by sliding it down and raising it (2) Insert one fresh alkaline 9-volt battery into the compartment. Make sure battery polarity is correct. 4 3 4 5 6 (3) Frequency select The group knob allows you to select any of seven frequency groups (numbered from 0-6). The channel knob allows you to select any of nine frequency channel
ملخص المحتوى في الصفحة رقم 8
(6) LED INDICATORS The POWER LED turns green when power is turned “On” or red if battery level is low. If this LED lights up red replace the battery. The AF PEAK LED lights up if the input level is set to high, indicating the onset of distortion. Lower the input level so that the AF PEAK LED lights only occasionally. To plug the 51XT onto a microphone (low impedance with XRL connector) first make certain the locking-ring is turned fully up (rotate counterclockwise). Then plug the 51XT fully in
ملخص المحتوى في الصفحة رقم 9
51BT with Lavaliere or Headset: With someone talking into the microphone, turn the volume on the mixer or amplifier to the desired level. If there is too much, or not enough gain, lower or raise the volume on the receiver. If the sound is distorted, lower the input gain on the transmitter. 51BT with Instrument cable for electric guitars or basses (MP-1H): Plug the cable into the guitar or bass. Set the instrument volume to the midway point. While playing the instrument, turn the volume on the mi
ملخص المحتوى في الصفحة رقم 10
Specifications Overall: Frequency Range: UHF 63 ch. (793-806MHz) Frequency Response: 20Hz to 20kHz Audio Distortion: less than 1% Dynamic Range: better than 100dB S/N Ratio: better than 95dB Operating Temperatures: 0 to 45 Operating Range: 100m under ideal conditions Oscillator: PLL synthesized Tone Squelch Frequency: 32.768kHz Diversity Type: True Space Diversity 51BT Transmitter: Type of Emission: FM Antenna: External Antenna µs Pre-emphasis: 50 MAX Input Level: -10dBm(Mic) +7dBm(MP-1) Microp
ملخص المحتوى في الصفحة رقم 11
51HT Transmitter: Type of Emission: FM Antenna: Internal Antenna Microphone Unit: Unidirectional Dynamic RF Output Power: 10m W (50mW MAX) Input Impedance: 8K Battery:2 1.5V (AA) Battery Life: 6 to 8 Hours with Alkaline Battery Dimensions: 56(D) 242(L) mm Weight: 250g (without battery) 51XT Transmitter: Type of Emission: FM Antenna: Internal Antenna µs Pre-emphasis: 50 MAX Input Level: -7dBm Microphone Unit: Dynamic Microphones RF Output Power: 15mW (50mW MAX) Input Impedance: 6K Audio Adj Rang
