ملخص المحتوى في الصفحة رقم 1
81038_4.book Page i Wednesday, March 24, 2004 3:17 PM
ST60 Depth
Instrument
Owner’s
Handbook
Document number: 81038-4
Date: 1 April 2004
ملخص المحتوى في الصفحة رقم 2
81038_4.book Page ii Wednesday, March 24, 2004 3:17 PM Raymarine, ST60 and SeaTalk are trademarks of Raymarine Limited © Handbook contents copyright Raymarine Limited 2004
ملخص المحتوى في الصفحة رقم 3
81038_4.book Page i Wednesday, March 24, 2004 3:17 PM Preface i Preface Important information Safety notices WARNING: Product installation & operation This equipment must be installed and operated in accordance with the Raymarine instructions provided. Failure to do so could result in personal injury, damage to your boat and/or poor product performance. WARNING: Electrical safety Make sure you have switched off the power supply before you start installing this product. WARNING: Alt
ملخص المحتوى في الصفحة رقم 4
81038_4.book Page ii Wednesday, March 24, 2004 3:17 PM ii ST60 Depth Instrument Owner’s Handbook
ملخص المحتوى في الصفحة رقم 5
81038_4.book Page iii Wednesday, March 24, 2004 3:17 PM Preface iii Contents Preface ......................................................................................................................i Important information ..................................................................................... i Safety notices .......................................................................................... i EMC conformance ............................................................
ملخص المحتوى في الصفحة رقم 6
81038_4.book Page iv Wednesday, March 24, 2004 3:17 PM iv ST60 Depth Instrument Owner’s Handbook Chapter 3: Installation .......................................................................................11 3.1 Planning your installation .....................................................................11 Site requirements .................................................................................11 Transducer .........................................................................
ملخص المحتوى في الصفحة رقم 7
81038_4.book Page v Wednesday, March 24, 2004 3:17 PM Preface v Introduction Thank you for purchasing a Raymarine product. We are sure your ST60 instrument will give you many years of trouble-free operation. This handbook describes how to install and use the Raymarine ST60 Depth instrument. This instrument provides accurate depth information, in either feet, meters or fathoms, on a high quality Liquid Crystal Display (LCD). The instrument is constructed in a rugged weather-proofed case to p
ملخص المحتوى في الصفحة رقم 8
81038_4.book Page vi Wednesday, March 24, 2004 3:17 PM vi ST60 Depth Instrument Owner’s Handbook not directly connected to a transducer but repeats information provided by other equipment in the SeaTalk network. The ST60 Depth instrument can fulfil both master and repeater roles. Stand alone operation In Stand alone operation, the ST60 Depth instrument is connected only to the relevant transducer and does not display information from, or provide information to, any other instruments. Remote c
ملخص المحتوى في الصفحة رقم 9
81038_4.book Page vii Wednesday, March 24, 2004 3:17 PM Preface vii Item 9, Owner’s Handbook. A Warranty document and fitting templates are included in this Handbook. Item 10, Cue Card. Spare spade terminals are also provided, to re-terminate the transducer cable if it has to be cut to facilitate installation. Note: The above packing list is for an ST60 Depth system. Where an instrument is pur- chased separately, a transducer is not included. 2 3 2 3 1 4 6 7 5 8 ST60 Depth Instrument Ow
ملخص المحتوى في الصفحة رقم 10
81038_4.book Page viii Wednesday, March 24, 2004 3:17 PM viii ST60 Depth Instrument Owner’s Handbook
ملخص المحتوى في الصفحة رقم 11
81038_4.book Page 1 Wednesday, March 24, 2004 3:17 PM Chapter 1: Operation 1 Chapter 1: Operation 1.1 Getting started This handbook describes how to operate, maintain and install the Raymarine ST60 Depth instrument. CAUTION: Calibration requirement The ST60 Depth instrument is calibrated to default settings when supplied. To ensure optimum performance on your boat, this product MUST be calibrated before use. Do NOT use the product until it has been calibrated using the procedures in Chapter
ملخص المحتوى في الصفحة رقم 12
81038_4.book Page 2 Wednesday, March 24, 2004 3:17 PM 2 ST60 Depth Instrument Owner’s Handbook Switch on Current depth depth depth Minimum depth Press Maximum depth reset for 3 s to reset MIN or MAX display depth Reading depth values D4347-1 Alarms An alarm condition occurs if: The depth is less than the SHALLOW or SHALLOW anchor threshold. The depth is more than the DEEP anchor threshold. The DEEP threshold value is crossed, with the seabed rising or falling. An alarm condition is indica
ملخص المحتوى في الصفحة رقم 13
81038_4.book Page 3 Wednesday, March 24, 2004 3:17 PM Chapter 1: Operation 3 alarm Shallow alarm alarm Deep alarm To enable/disable any alarm Press reset for 1 second (toggle action) To enter/exit adjust mode alarm Press offset and reset together In adjust mode, use offset reset to increase to decrease, or Shallow anchor alarm alarm Deep anchor alarm Alarm thresholds D4348-1
ملخص المحتوى في الصفحة رقم 14
81038_4.book Page 4 Wednesday, March 24, 2004 3:17 PM 4 ST60 Depth Instrument Owner’s Handbook Offsets Depths are measured from the transducer to the sea bed. However, offsets to the actual distances measured can be applied during calibration (see Chapter 4, Calibration ), so that the displayed depth reading represents either the depth from the keel or the depth from the waterline (W/L). To see the offsets applied on your vessel, press the offset key. If the instrument is operating as a mast
ملخص المحتوى في الصفحة رقم 15
81038_4.book Page 5 Wednesday, March 24, 2004 3:17 PM Chapter 1: Operation 5 1.4 Pop-up Pilot A Pop-up Pilot facility enables instruments connected to SeaTalk to constantly monitor any changes to the autopilot mode and to the course settings. If one of these parameters changes, the new value is immediately displayed on the ST60 instrument for 5 seconds, after which time the display reverts to the previous display. This facility can be enabled or disabled during User calibration (see Chapter
ملخص المحتوى في الصفحة رقم 16
81038_4.book Page 6 Wednesday, March 24, 2004 3:17 PM 6 ST60 Depth Instrument Owner’s Handbook
ملخص المحتوى في الصفحة رقم 17
81038_4.book Page 7 Wednesday, March 24, 2004 3:17 PM Chapter 2: Maintenance & Troubleshooting 7 Chapter 2: Maintenance & Troubleshooting 2.1 Maintenance Servicing and safety Raymarine equipment should be serviced only by authorised Raymarine ser- vice technicians. They will ensure that servicing procedures and replacement parts used will not affect performance. There are no user-serviceable parts in any Raymarine product. Some products generate high voltages, and so never handle the cable
ملخص المحتوى في الصفحة رقم 18
81038_4.book Page 8 Wednesday, March 24, 2004 3:17 PM 8 ST60 Depth Instrument Owner’s Handbook Cabling Examine all cables for chafing or other damage to the outer shield and, where necessary, replace and re-secure. 2.2 Troubleshooting Preliminary procedures Changes in the electronic environment may adversely affect the operation of your ST60 equipment. Typical examples of such changes are: Electrical equipment has recently been installed or moved aboard your vessel. You are in the vicinity
ملخص المحتوى في الصفحة رقم 19
81038_4.book Page 9 Wednesday, March 24, 2004 3:17 PM Chapter 2: Maintenance & Troubleshooting 9 Technical support Raymarine provides a comprehensive customer support service, on the world wide web and by telephone help line. Please use either of these facilities if you are unable to rectify a problem. World wide web Please visit the Customer Support area of our web site at: www.raymarine.com As well as providing a comprehensive Frequently Asked Questions section and servicing information,
ملخص المحتوى في الصفحة رقم 20
81038_4.book Page 10 Wednesday, March 24, 2004 3:17 PM 10 ST60 Depth Instrument Owner’s Handbook
