ملخص المحتوى في الصفحة رقم 1
Barbecue Stainless 5000AS
SAFE USE, CARE AND ASSEMBLY MANUAL
FOR YOUR SAFETY
If You Smell Gas
1. Immediately turn off the flow of gas to
the unit.
2. Extinguish any open flame.
3. Open the lid of the unit.
4. If the odour does not stop quickly, immedi-
ately call your gas supplier or Fire
Department for assistance.
FOR YOUR SAFETY
1. Do not store or use gasoline or other
flammable vapours and liquids in the
vicinity of this or other appliance.
2. An LP Gas cylinder not connected for
use shall no
ملخص المحتوى في الصفحة رقم 2
TABLE OF CONTENT S WARRANT Y 5 Year Limited Warranty Warranty . . . . . . . . . . . . . . . . . ii This Centro BBQ carries a five year limited warranty against defects in manufacturing Installation . . . . . . . . . . . . . . . 1 workmanship. This Limited Warranty is nontransferable and becomes void if used for commercial or rental purposes. This warranty applies only when grill is used in Canada. Additional Warnings . . . . . . . . 1 The bill of sale or a copy will be required together with the
ملخص المحتوى في الصفحة رقم 3
INSTALLATION The installation of this appliance must be in accordance with all local codes, or in the absence of local codes: • Canadian installation must conform to the current national standards, which at this time are CAN/CGA-B149.1/2-Natural Gas/Propane installation code. • For natural gas barbecues, contact a certified gas-technician to install your unit. ADDITIONAL Minimum clearance to adjacent combustible materials: • 76 cm (30˝) from furthest protruding edge on side of barbecue. WARNINGS
ملخص المحتوى في الصفحة رقم 4
The Cylinder must also be equipped with: • A shut-off valve with a correct cylinder valve outlet as specified in current standards. • Canada: CAN/CGA 1.6g-M97 Outdoor Gas Grilles. a) A safety relief valve with direct connection to the vapour space of the cylinder. b) A collar to protect the tank shut-off valve. c) A device for vapour withdrawal. d) A ring on the bottom to secure the tank to its support assembly. • Always turn off the cylinder valve completely when the barbecue is not in use. • A
ملخص المحتوى في الصفحة رقم 5
HOSE AND Propane Gas Models: Your barbecue is designed to operate on L.P. (Propane) gas at a pressure of 2.74 Kpa (11˝ water column). A regulator preset to this pressure is supplied REGULATOR with the barbecue and must be used. This regulator is equipped with the Type-1 quick-closing connecting system, which incor- porates these safety features: • Will not allow gas to flow until a positive seal has been made. • Has a thermal component that will automatically shut off the flow of gas between 11
ملخص المحتوى في الصفحة رقم 6
The Following Must be Checked • The tank valve including the threads into the tank (drawing C). • All tank welds (drawing B). • Regulator fittings and tank connections (drawing C). • All hose connections (drawing D). • With a newly filled and tested propane tank attached to the barbecue and all the barbecue controls turned “OFF”, slowly open Drawing B Drawing C the cylinder valve one full turn. • Using a brush and soap, soak all the connections and components listed above and shown in drawings B
ملخص المحتوى في الصفحة رقم 7
• LIGHTING Make sure you have followed all the checks, procedures and instructions indicated in the prior sections before attempting to light the grill. THE GRILL • Always raise the barbecue lid before lighting the burner. • Do not bend directly over the barbecue while lighting in case of back flash. • Making sure all the control knobs are off, slowly and carefully open the propane gas cylinder valve. Wait about five seconds before opening the burner valve and lighting the barbecue. This proce
ملخص المحتوى في الصفحة رقم 8
WARNING If the heat output is too low, the flow control feature may have been activated by a gas leak. If so, turn off the burner valve and cylinder valve, and perform the “Leak Test”. If there aren’t any leaks, re-light the burner. Lighting the Second Burner • Turn the second control knob on the main control panel to the “HIGH” position. The unlit burner will automatically ignite. Lighting the Side Burner Use the push-button igniter on the main control panel and the right control knob on th
ملخص المحتوى في الصفحة رقم 9
• ROTISSERIE BURNER Turn all knobs to “OFF” • Open lid during lighting. Turn gas on at LP tank. IGNITER LIGHTING • Push in and turn Rotisserie Burner knob to “HI”. • Push the Igniter. Be sure burner lights and stays lit. • If Igniter does not work , follow match light instruction. Match Lighting • Open Lid. Turn on gas at LP tank. • Place lit match near porthole of burner. • Push in and turn Rotisserie Burner knob to “HI”. Be sure burner lights and stays lit. TIPS ON USING Guide to Rotisserie Co
ملخص المحتوى في الصفحة رقم 10
TIPS ON USING Using for the First Time: Before cooking, turn on the grill and operate on “HIGH” for about 10–15 minutes with the lid open. Close the lid and continue to run the grill on YOUR BARBECUE “HIGH” for another few minutes. After this, your grill should be burned in and ready to use. Preparation: The barbecue should be preheated before adding any food. This is done by lighting the grill and running at “HIGH” for up to ten minutes with the lid down. If the food you are cooking needs a low
ملخص المحتوى في الصفحة رقم 11
INFORMATION ON This model has a 12’ hose with a male coupling plug that will allow you to attach your barbecue to your residential gas line. NATURAL GAS MODEL WE STRONGLY RECOMMEND CONTACTING A CERTIFIED GAS-TECHNICIAN TO INSTALL YOUR NATURAL GAS UNIT. Connecting to Gas Line 1. Pull back the outer sleeve located on the residential gas line (see illustration). 2. Insert the barbecue’s male coupling plug into the residential gas line’s coupling. 3. Push the male coupling plug in as far as possib
ملخص المحتوى في الصفحة رقم 12
CLEANING To get many years of service out of your barbecue, perform the following procedures at least once a year, especially at the start of a new season. AND MAINTENANCE Grill: Apply a light coating of cooking oil to the grating to prevent food from sticking. After each use, and after the barbecue has cooled down, scrub the grating with a non-abrasive brush. Alternatively, you can wash the grating with a mild detergent or baking soda, but do not use a commercial oven cleaner. Burner and Ventur
ملخص المحتوى في الصفحة رقم 13
TROUBLESHOOTING GUIDE Problem Possible Causes Corrective Action • • Burner will not light Blocked Venturi tubes Clean out blockage (match or igniter) • • Cylinder or gas supply valve turned off Open cylinder or gas supply valve Burners not hot enough • • Venturi tubes not properly sealed over orifices Ensure proper Venturi assembly • • Burner ports blocked Clean/replace burner • • Low or out of propane Refill cylinder • • Regulator safety devise must be re-set Follow How to Reset the Gas Regula
ملخص المحتوى في الصفحة رقم 14
Item No. Quantity Description Part No./Spec. PA RTS LIST FOR A 1 Top Lid Assembly 85-1283-8 (PROPANE) AA 1 Top Lid Weldment G607-0100-01 AB 1 Handle – Top Lid G607-0001-01 AC 1 Thermometer G401-0005-01 B 1 Burner Box Assembly BA 1 Burner Box Weldment G607-0200-01 BB 3 Main Burner G607-6000-01 BC 1 Burner Brace Assembly G607-0006-01 BF 1 Warming Rack G607-0003-01 BG 3 Cooking Grate, Burner Box G607-0004-01 BH 4 Flame Tamer G607-0005-01 1 Heat Shield A G607-0025-01 CA 1 Side Panel, Left G607-0300-
ملخص المحتوى في الصفحة رقم 15
85-1277-4 (PROPANE) BG AC AA BH BB AB BF BC BA HI DA FE EA FF EB CC HJ GA HA CD FH FC FG CB HE FH CA FA FB HI EB HF HS HR HK HD HC HB HP HQ HN HO HM HL 13
ملخص المحتوى في الصفحة رقم 16
Item No. Quantity Description Part No./Spec. PA RTS LIST FOR A 1 Top Lid Assembly 85-1210-2 (NATURAL GAS) AA 1 Top Lid Weldment G607-0100-01 AB 1 Handle – Top Lid G607-0001-01 AC 1 Thermometer G401-0005-01 B 1 Burner Box Assembly BA 1 Burner Box Weldment G607-0200-01 BB 3 Main Burner G607-6000-01 BC 1 Burner Brace Assembly G607-0006-01 BF 1 Warming Rack G607-0003-01 BG 3 Cooking Grate, Burner Box G607-0004-01 BH 4 Flame Tamer G607-0005-01 1 Heat Shield A G607-0025-01 CA 1 Side Panel, Left G607-0
ملخص المحتوى في الصفحة رقم 17
85-1210-2 (NATURAL GAS) BG AC AA BH BB AB BF BC BA HI DA FE EA FF EB CC HJ GA HA CD FH FC FG CB HE FH CA FA FB HI EB HF HS HR HK HD HC HB HP HQ HT HN HO HM HL 15
ملخص المحتوى في الصفحة رقم 18
ASSEMBLY INSTRUCTIONS Hardware Pack List No. Description Part Number Quantity Tools Needed for Assembly 1 1/4”-20UNC x 13 Screw 20120-13013-250 6 2 Ø7 Washer 40300-07000-250 6 ® • • #2 Phillips screwdriver Pliers 3 Ø7 Lock Washer 41400-07000-250 6 • • 1/4˝ slotted screwdriver Rubber mallet 4 No.10-24UNC x 10 Screw 20124-10010-250 6 • 5 Ø5 Washer 40300-05000-250 6 Adjustable wrench 6 Ø5 Lock Washer 41400-05000-250 6 Before assembling the barbecue, read these instructions carefully. 7 AA BATTERY G
ملخص المحتوى في الصفحة رقم 19
1 Open top lid (A) and position the four flame tamers (BH) as shown. Place the three cooking grates (BG) above the flame tamers. 2 Attach the warming rack (BF) to the inside of the top lid (AA) as shown. Make sure the two legs of the warming rack clip onto the edge of the burner box weldment (BA). 3 Remove the screws & washers from both side shelves’ handles (FH). Assemble the side handles (FH) to the side shelf (GA) and side burner shelf by using the same screws and washers which were just remo
ملخص المحتوى في الصفحة رقم 20
4 Assemble the side burner shelf assembly (F) to the upper left side panel (CA) by using hardware No. 1, 2, 3 (x3) and No. 4, 5, 6 (x2). Assemble the side shelf assembly (G) to the right side panel (CB) using same hardware as above. 5 Push the side burner valve stem and mount it by using screws and washers included on the valve bracket, threading through the side burner control panel. Push the knob (EB) onto the valve s tem wi th the whi te l ine on the knob pointing upwards. Insert the side bur
