SkyLink GM-318 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TM
Garage Door Monitor Model GM-318
2. SET UP CODE CONNECTORS AND ZONE CONNECTORS (CONT)
1. INTRODUCTION
TM
The garage door monitor is designed to monitor the status of your
A B
“+” on the table means the connector for
garage door and advise you if the door is open. By placing the sensor
that position should be placed on the
on the door panel, you will be alerted when the door is open. When the Zone 1 + +
posts.
garage door is open, receiver will beep and flash.
Zone 2 + -
Zone 3 - +
TM
“-” on

ملخص المحتوى في الصفحة رقم 2

4. INSTALLATION (CONT) 8. LOSS OF SIGNAL INDICATION When the battery level on the sensor drops to a certain level, or the sensor is out of the operating range, the receiver will show a “loss of signal” indication. The red LED representing that zone will flash rapidly, i.e. if zone 1 sensor is lost, the zone 1 red LED will flash rapidly. When the loss of signal indication occurs, move the receiver closer to One of the corresponding sensor and trigger that sensor. If the red LED stops Vertical fl