Sears 139.53716 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

o
Touch Code Lock
NIodel 139.53716
n
KEYBOARD CONSOLE
The Touch Code Lock consists of a keyboard and a console The keyboard sends a coded signal from outside the garage
The console fastens to an inside garage wall it receives the 4-digit programmed coded signal and _tarts the door opener
The Touch Code Lock will work with most Genie "Push Twice to Operate" openers if you press any other digit after
you enter the 4-digit programmed code°
NOTE: CABLE CONNECTOR HOLE IS LOCATED ON LEFT SIDE OF CONSO

ملخص المحتوى في الصفحة رقم 2

STEP 4: Position console on an interior garage wall approxi- NOTE: if your garage has a built up jamb, drill the hole mately one foot from outside edge of door. Fasten with (2) 2" deep. Then, on inside edge of jamb, drill a second hole 8ABxl" screws into first hole to complete access_ Run bell wire up wall and across ceiling to garage door opener terminals Use insulated staples to secure wire Cut off any excess wire Connect to terminals used for push button l/8" Pilot Hole I _'_--_ controls "4 1