Genie 37026500123 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Move in this direction
Move in this direction
DOOR LIMITS FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
6
WARNING
Limit Controls location
on power head.
• Severe injury or death can result if the door
closing force is set too high.
NOTE: Set Close Travel Limit
• Never increase the door closing force above the
before setting Open Travel
minimum required to move the door.
Limit for unit to operate
• Never adjust force to compensate for a sticking
normally.
or binding door.
Unless limits a

ملخص المحتوى في الصفحة رقم 2

CARRIAGE LOCK DOOR The Carriage Lock can be manually engaged or disengaged. • To disengage Carriage Lock – Pull handle downward opener power head. • To engage Carriage Lock – Pull handle towards door. LOCK UNLOCK TO RELEASE TO RECONNECT PULL TOWARD PULL TOWARD DOOR THE OPENER FIG. 6-3 Engage/Disengage Carriage Lock. KEYED EMERGENCY RELEASE (PURCHASED SEPARATELY) Obtain standard emergency release kit and remove S-hook from the cable end that attaches to the opener carriage. 1. Attach the

ملخص المحتوى في الصفحة رقم 3

UP/DOWN FORCE CLOSE 1. By turning the "Close Force Control" clock- Up Force Control wise, the DOWN force can be increased. By OPEN Adjustment CLOSE turning the "Close Force Control" counter- clockwise, the DOWN force can be decreased. (Increasing Force) Set the DOWN force level at the minimum force required to close door without reversing. ROTATE FORCE CLOCKWISE 2. Once the desired level is selected, this stores the necessary force level for the DOWN direction in memory. OPEN (Decreasing For

ملخص المحتوى في الصفحة رقم 4

PROGRAMMING REMOTE CONTROLS 7 WARNING A moving door can cause serious injury or death. 1. Keep people clear of opening while door is moving. NOTE: To program a 2. Do NOT allow children to play with opener, ® ® Homelink and Car2U including wall button, remote control, or ® ® Wireless Keypad. device follow the Homelink or Car2U 3. During programming, the door opener could instructions in your car owner’s manual. begin to run, so keep people and objects away from the moving door and its parts.

ملخص المحتوى في الصفحة رقم 5

BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION REMOTE CONTROL 8 1. Battery replacement. Slide out • To open, gently push straight out on battery cover lock tab as shown. (Fig. 8-1). • Slide open battery cover. – Remove old battery. • Make sure new battery is facing proper direction (Match battery polarity with symbols inside battery housing) (Fig. 8-2). – Recommended replacement battery type: Alkaline A23, 12 volt. NOTE: Batteries differ in care and maintenance. FIG. 8-1 Open battery cover