Havis-Shields Ford Crown Victoria C-3190-F دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALL INSTRUCTIONS C-3190-F
1996-2007 FORD CROWN VICTORIA

TOOLS REQUIRED:
7/16” wrench and socket Power Drill and ¼” drill bit

HARDWARE:
QTY DESCRIPTION PART #
8 ¼-20 x 1” Hex Head Cap Screw GSM33002
12 ¼” Flat Washer GSM31005
12 ¼-20 Hex Head Flange Nut GSM30023
8 ¼-20 x ½” Hex Head Cap Screw GSM33000
4 3/8-16 Hex Nut GSM30008
1 12” – ¼” Loom PRM97913

Step 1. Slide Tray out of housing.
Step 2. Place left and right support arms in place and fasten down with (4) ¼-20 x ½”

ملخص المحتوى في الصفحة رقم 2

TECHNICAL SERVICE BULLETIN Subject: Trunk Tray Installation (Part # C-3190-F: Full Width Tray ) Vehicle: 2005 and newer Ford Crown Victoria Police Interceptor Problem: The Fuel Pump wire harness on 2005 mid model year Crown Victoria’s and newer is now routed on the rear (trunk) side of seat strainer (metal framework behind rear seat). The location of this harness now interferes with the mounting bracket for the Havis-Shields full width trunk tray. Harness is subject to being pinched