Emerson ACM1000M-XXX دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Media Air Cleaner
With Media Filter
Model Number
ACM1000M-XXX
ACM1400M-XXX
ACM1600M-XXX
ACM2000M-XXX
OWNERS MANUAL
• Installation
• Operation
• Maintenance
Please read and familiarize yourself with the contents of this manual before
installing, operating or performing maintenance on the unit.
White-Rodgers is a division
PART NO. 37-7001A
of Emerson Electric Co.
www.white-rodgers.com
0922

ملخص المحتوى في الصفحة رقم 2

INTRODUCTION The Emerson Media Air Cleaner comes complete with a 4” GUARANTEE media furnace air fi lter. This fi lter must be changed every three Emerson will not assume any responsibility for component to six months to maintain effi ciency of the fi lter and furnace failures due to incorrect installation procedures. system. Please read instructions before installing and using the Air RULES FOR SAFE INSTALLATION Filter Compartment. AND OPERATION 1. Read the Owners Manual and the Rules for

ملخص المحتوى في الصفحة رقم 3

HOW THE AIR FILTER WORKS Dirty air fl ows through your return air ducts and enters the compartment where particles (hair, lint, etc.) are removed by 4" FILTER the fi lter. See fi gure 1. Filtered air re-enters to the supply duct system of your building. DIRTY AIR IN FILTERED AIR OUT Figure 1 CONSTRUCTION OF THE AIR FILTER COMPARTMENT Not only is your air fi lter compartment easy to install, it is also easy to maintain. Its basic components, and their functions, are as follows: (See Figure 2)

ملخص المحتوى في الصفحة رقم 4

PREINSTALLATION 3. The air fi lter is not to be placed in the discharge of either the LOCATING THE AIR FILTER heating or cooling unit. Your air fi lter must be mounted in the return air duct of a central 4. IMPORTANT: If atomizing spray type humidifi er is used, it forced-air system, on the air entering side of your furnace. (See must be installed downstream from the air fi lter. Figure 3 for example). If furnace opening cannot be enlarged to required size, a Select a location that meets the

ملخص المحتوى في الصفحة رقم 5

TYPICAL MOUNTING POSITIONS AIR FLOW AIR FLOW Figure 5 Figure 6 BASEMENT FURNACE (LOWBOY) COUNTERFLOW Filter is mounted horizontally FURNACE in return plenum, just above Filter is mounted horizontally furnace. in return duct or plenum, just above furnace. AIR FLOW Figure 7 Figure 8 HIGHBOY FURNACE HIGHBOY FURNACE Side installation. Filter is Installation beneath furnace. mounted vertically, where Filter mounts horizontally, return air enters side inlet of where return air enters fr

ملخص المحتوى في الصفحة رقم 6

INSTALLATION REMOVE OLD FILTER AND DISCARD (Figure 11) NOTE: This fi lter may be mounted in the furnace compartment. CLEAN BLOWER COMPARTMENT NOTE: The air fi lter cannot remove dirt from blower and ducts. Figure 11 INSTALLATION The following is a typical installation of the air fi lter on a “Highboy” furnace (Figure 7). 1. Place the air fi lter compartment on the fl oor. Stand it upright Frame with the door facing you (Figure 2). If a horizontal installation is being planned, lay the compartme

ملخص المحتوى في الصفحة رقم 7

NOTES 7

ملخص المحتوى في الصفحة رقم 8

White-Rodgers is a division of Emerson Electric Co. The Emerson logo is a trademark and service mark of Emerson Electric Co. www.white-rodgers.com