ملخص المحتوى في الصفحة رقم 1
OWNER'S MANUAL
Wide Plasma Display
Owner's Record
The model number and serial number are on the back
of your display. Record these numbers in the spaces below.
Refer to these numbers whenever you communicate
with your Toshiba dealer about this display.
Model number: 50HP82
Serial number:
50HP82
TOSHIBA CORPORATION, 2002
ملخص المحتوى في الصفحة رقم 2
Important Information Precautions Warnings and Safety Precaution Please read this manual carefully before using your TOSHIBA The TOSHIBA plasma display is designed and plasma display and keep the manual handy for future manufactured to provide long, trouble-free service. reference. No maintenance other than cleaning is required. Use a soft dry cloth to clean the panel. Never use solvents such as alcohol or thinner to clean the panel CAUTION surface. The plasma display panel consists of fi
ملخص المحتوى في الصفحة رقم 3
Recommendations to avoid or minimize phosphor burn-in NOTE: When you connect a computer to this display, attach Like all phosphor-based display devices and all other gas the supplied ferrite cores. If you do not do this, this plasma displays, plasma displays can be susceptible to display will not conform to mandatory FCC standards. phosphor burn under certain circumstances. Certain To attach the ferrite cores: operating conditions, such as the continuous display of a Set the ferrite cores on bot
ملخص المحتوى في الصفحة رقم 4
Contents Important Information...................................... 2 OSD Controls ................................................. 22 Menu Operations ................................................... 22 How to Attach Options to the Plasma Display ..... 5 Picture Settings Menu............................................. 24 Adjusting the picture ................................................. 24 Introduction ..................................................... 6 Setting the picture mode a
ملخص المحتوى في الصفحة رقم 5
How to Attach Options to the Plasma Display You can attach your optional mounts or stand to the plasma display in one of the following two ways: Drawing A • While it is upright. (See Drawing A) • As it is laid down with the screen face down (See Drawing B). Lay the protective sheet, which was wrapped around the display when it was packaged, beneath the screen surface so as not to scratch the screen face. • This device cannot be installed on its own. Be sure to use a stand or original mounting un
ملخص المحتوى في الصفحة رقم 6
Introduction Introduction to the 50HP82 Plasma Display Contents of the Package TOSHIBA’s 50HP82 Plasma Display is a seamless blend 50HP82 plasma display of cutting-edge visual technology and sophisticated design. Power cord At 50 inches, with a 16:9 aspect ratio, the 50HP82 certainly makes a big impression. However, at a mere 4.2 inches/ RGB cable (Mini D-Sub 15-pin to Mini D-Sub 15- 107 mm thin, the display’s sleek techno-art lines blend in pin connector) well with your environment. The p
ملخص المحتوى في الصفحة رقم 7
Part Names and Function Front View POWER/STANDBY INPUT SELECT VOLUME POWER/STANDBY VOLUME INPUT SELECT PROCEED DOWN UP LEFT/— RIGHT/+ /EXIT q PROCEED t POWER/STANDBY indicator Sets the On-Screen Display (OSD) mode and displays When the power is on ............................. Lights green. the main menu. When the power is in the standby mode ... Lights red. w VOLUME DOWN and UP y Power Adjusts the volume. Functions as the CURSOR Turns the display’s power on and off. ( / ) buttons in the On-Sc
ملخص المحتوى في الصفحة رقم 8
Rear View/ Terminal Board VIDEO 1 VIDEO 2 B VIDEO 3 ( ) L MONO R VIDEO 1 Y VIDEO 2 VIDEO 3 ( ) L MONO CB / PB R C Y CB / PB CR/PR CR / PR L ( MONO ) R L ( MONO ) RGB 1 R R/CR/PR G/Y B/CB/PB HD VD RGB 1 L ( MONO ) R D RGB 3 (Digital RGB) R/CR/PR CONTROL LOCK ON / OFF SPEAKERS MUST HAVE MORE THAN 7WATT RATING REMOTE CONTROL IMPEDANCE 6 OHM G/Y RIGHT LEFT EXTERNAL CONTROL B/CB/PB AC-IN E HD VD K SPEAKERS MUST L ( MONO ) HAVE MORE THAN J 7WATT RATING R IMPEDANCE 6 OHM RIG
ملخص المحتوى في الصفحة رقم 9
Remote Controller w RGB/PC Press this button to select RGB/PC as the source. → RGB/PC1 → RGB/PC2 → RGB/PC3 RGB/PC can also be selected using the INPUT SELECT button on the display. The input switches as follows each time the button is pressed: → VIDEO1 → VIDEO2→ VIDEO3→ DVD/HD RGB/PC3 ← RGB/PC2 ← RGB/PC1 ← e DVD / HD Press this button to select DVD/HD as the source. DVD/HD can also be selected using the INPUT SELECT button on the display. The input switches as follows each time the button i
ملخص المحتوى في الصفحة رقم 10
!3 DISPLAY Battery Installation and Replacement Displays the source settings on the screen. Insert the 2 “AAA” batteries, making sure to set them in with the proper polarity. !4 OFF TIMER Activates the off timer for the unit. 1.Press and open the cover. !5 MULTI Press this button to select a screen mode from among single mode, side-by-side, and picture-in-picture. !6 SELECT Press this button to select the active picture in a multi window mode. !7 AUTO ADJUST Press this button to adjust Fine Pict
ملخص المحتوى في الصفحة رقم 11
Using the wired remote control mode Operating Range Connect the supplied remote cable to the remote • Use the remote controller within a distance of about 23ft / controller’s remote jack and the “REMOTE CONTROL” 7 m. from the front of the display’s remote control sensor terminal on the display. and at horizontal and vertical angles of up to approximately When the cable is connected, the mode automatically 30°. switches to wired remote control. When the wired remote • The remote control operation
ملخص المحتوى في الصفحة رقم 12
Installation To video inputs on the plasma display VCR VIDEO 1 VIDEO 2 VIDEO 3 L ( MONO ) R Y CB / PB CR / PR ( ) L MONO R IBM VGA or Compatibles RGB 1 R/CR/PR G/Y B/CB/PB HD Signal cable (supplied) To Mini D-Sub 15-pin connector on the plasma display VD ( ) L MONO R RGB 3 ( ) Digital RGB CONTROL LOCK ON / OFF REMOTE An image may not be displayed CONTROL correctly if a video source like a DVD Player EXTERNAL VCR is connected to the DVD terminals. CONTROL Personal computer with a
ملخص المحتوى في الصفحة رقم 13
Connecting Your PC Connecting Your VCR Connecting your PC to your plasma display will enable you Use common RCA cables (not provided) to connect your to display your computer’s screen image for an impressive VCR to your plasma display. To make these connections: presentation. The plasma display supports the signals described on page 45. 1. Turn off the power to your plasma display and VCR. To connect a PC or compatible graphics adapter: 2. Connect one end of your RCA cable to the video output 1.
ملخص المحتوى في الصفحة رقم 14
External Speaker Connections VIDEO 1 VIDEO 2 VIDEO 3 L ( MONO ) R Y CB / PB CR / PR L ( MONO ) RIGHT LEFT R RGB 1 R/CR/PR G/Y B/CB/PB HD VD L ( MONO ) R RGB 3 ( ) Digital RGB CONTROL LOCK ON / OFF SPEAKERS MUST HAVE MORE THAN REMOTE 7WATT RATING IMPEDANCE 6 OHM CONTROL RIGHT LEFT EXTERNAL CONTROL AC-IN External speakers (optional) may be connected to the To connect external speakers directly to the plasma display: plasma display to reproduce sound from VIDEO, DVD or 1. Strip the en
ملخص المحتوى في الصفحة رقم 15
Pin Assignments and Signal Levels for 15-pin RGB (Analog) Pin No. Signal (Analog) 5 4 3 2 1 1 Red 10 9 8 7 6 2 Green or sync-on-green 15 14 13 12 11 3 Blue 4 No connection 5 Ground 6 Red ground 7 Green ground 8 Blue ground 9 No connection 10 Sync signal ground 11 No connection 12 Bi-directional DATA (SDA) 13 Horizontal sync or Composite sync 14 Vertical sync 15 Data clock Pin Configuration and Signal of the RGB 3 IN Connector (DVI Connector) The unit is equipped with a type of connector commonly
ملخص المحتوى في الصفحة رقم 16
Basic Operations POWER DIGITAL ZOOM To turn the unit ON and OFF: Digital zoom specifies the picture position and enlarges the picture. 1. Plug the power cord into an active AC power outlet. 1. Press the POINTER button to display the pointer. ( ) 2. Press the POWER ON button to turn on the unit. To change the size of the picture: The display’s POWER/STANDBY indicator will light Press the ZOOM+ button and enlarge the picture. up (green) when the unit is on. The pointer will change to resemble a m
ملخص المحتوى في الصفحة رقم 17
To cancel the off timer: OFF TIMER To set the off timer: 1. Press the OFF TIMER button twice in a row. The off timer can be set to turn the power off after 30, 60, 2. The off timer is canceled. 90 or 120 minutes. 1. Press the OFF TIMER button to start the timer at 30 OFF TIMER 0 minutes. 2. Press the OFF TIMER button to the desired time. 3. The timer starts when the menu turns off. → 30 → 60 → 90 → 120 → 0 OFF TIMER 30 Note: After the power is turned off with the off timer, a slight current is
ملخص المحتوى في الصفحة رقم 18
WIDE Operations JUST size screen Watching with a wide screen (manual) With this function, you can select one of four screen sizes. When watching VCR’s or DVD 1. Press the WIDE button on the remote controller. 2. Within 3 seconds ... Press the WIDE button again. The picture is expanded in the horizontal and vertical directions at different ratios. The screen size switches as follows: • Use this for watching normal video programs (4:3) with a → ZOOM → NORMAL → FULL → JUST wide screen. When watchin
ملخص المحتوى في الصفحة رقم 19
FULL size screen Watching computer images with a wide screen Switch to the wide screen mode to expand the 4:3 image to fill the entire screen. 1.Press the WIDE button on the remote controller. 2.Within 3 seconds ... Press the WIDE button again. The image is expanded in the horizontal and vertical The screen size switches as follows: direction. → NORMAL → FULL NORMAL size screen (4:3 or SXGA 5:4) TRUE The picture has the same size as the normal computer The image is true resolution. image. FULL F
ملخص المحتوى في الصفحة رقم 20
MULTI WINDOW Operations Operations in the Side-by-side mode Showing two pictures on the screen at the same time To change the picture size, press the cursor or button. • An RGB-input picture may not be displayed in these modes, VIDEO1 RGB/PC1 depending on the input signal specifications. A B 1. Press the MULTI button to select a screen mode from among single mode, side-by-side, and picture-in-picture. button button Side-by-side VIDEO1 RGB/PC1 VIDEO1 RGB/PC1 AB AB button button
