Edelbrock Performer-Plus 2132 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMER-PLUS
CAMSHAFT / LIFTERS / LUBE KIT
CATALOG # 2132
MODEL: 304-360-401 c.i.d. AMC V8 engines
GENERAL INSTRUCTIONS
• Please study these instructions carefully before you remove your stock camshaft. If you have any questions or problems, do not hesitate to con-
tact our Technical Hotline at: 1-800-416-8628.
� These instructions are designed to give general installation guidelines. A complete step-by-step procedure manual would require many pages. If
you are a novice or just learning to

ملخص المحتوى في الصفحة رقم 2

13. Remove crankshaft pulley, and using a suitable puller, crankshaft 3. Install camshaft with timing marks lined up as recommended by fac- dampener. tory specifications. See Figure 2. 14. Remove two front oil pan bolts. Remove bolts securing timing chain cover to block. � PUSHROD AND ROCKER ARM INSTALLATION—After the cam is NOTE: Bolts vary in length and must be installed in same location as installed and timed correctly (see Figure 2), install pushrods, lifters and removed. Pull cover forward

ملخص المحتوى في الصفحة رقم 3

3. Lightly tighten the hold-down clamp so that the distributor can still � CAM GEARS AND CAMSHAFT END PLAY— If cam gear becomes be turned to determine final setting using a timing light with the loose, the cam will slide back in the block, causing the lifters to hit engine running. the lobes next to them and also the cam bearing journals. If the 4. Replace valve covers, carburetor linkage and remaining vacuum and engine is run after this happens, the bottom of the lifters and the electrical conn

ملخص المحتوى في الصفحة رقم 4

CAMSHAFT: Performer-Plus CAMSHAFT: Performer-Plus CATALOG #2132 CATALOG #2132 ENGINE: 304-401 c.i.d. AMC V8 ENGINE: 304-401 c.i.d. AMC V8 RPM RANGE: 1500-5500 RPM RANGE: 1500-5500 CAUTION: CAUTION: Use only Sure Seat Valve Springs, #5832 or 5932 Use only Sure Seat Valve Springs, #5832 or 5932 Use stock ratio rocker arms only Use stock ratio rocker arms only Duration at 0.006" Lift: Intake: 278° Exhaust: 288° Duration at 0.006" Lift: Intake: 278° Exhaust: 288° Duration at 0.050" Lift: Intake: 204