Edelbrock Performer RPM 7167 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMER RPM
Camshaft/Lifters/Lube Kit
#7167 for 1968-87
429/460 Ford V8
• PLEASE study these instructions carefully before installing
 TO AVOID ANY PROBLEMS DO THE FOLLOWING:
your new camshaft. If you have any questions or problems, do
Carefully study and understand all instructions. Examine the
not hesitate to call our Technical Hotline at: 800-416-8628.
camshaft for possible shipping damage (if damaged contact
your dealer immediately).
 CAMSHAFT: Edelbrock Performer RPM camshafts are
groun

ملخص المحتوى في الصفحة رقم 2

11. Remove crankshaft pulley and, using a suitable puller, crank-  VALVE SPRINGS shaft dampener. CAUTION: WARNINGS ABOUT YOUR WARRANTY 12. Loosen oil pan and remove front cover. In order for this Performer RPM cam and lifter kit to be cov- NOTE: The front cover oil seal should be replaced before the ered under ANY WARRANTY you MUST use the correct front cover is re-installed. Edelbrock Sure Seat Valve Springs. Failure to install new 13. Rotate engine until timing marks are aligned as shown in E

ملخص المحتوى في الصفحة رقم 3

 CAMSHAFT/LIFTER RUN-IN  IGNITION TIMING Ignition timing for this package may vary with each application. CAUTION: Change the engine oil and filter before start-up A good starting figure would be between 10 degrees to 14 and again after the initial break-in. Do not allow the engine to degrees initial timing at idle with vacuum advance disconnected. run under 2000 rpm for the first 1/2 hour. Vary engine speed Total advance should not exceed 32 degrees to 34 degrees with between 2000 and 2500 rp

ملخص المحتوى في الصفحة رقم 4

CAMSHAFT: Performer RPM Hydraulic CAMSHAFT: Performer RPM Hydraulic CATALOG #7167 CATALOG #7167 ENGINE: Ford 429/460 V8 ENGINE: Ford 429/460 V8 RPM RANGE: 1500-6500 RPM RANGE: 1500-6500 CAUTION: Do not use racing type dual valve springs. Use CAUTION: Do not use racing type dual valve springs. Use only recommended Edelbrock Sure Seat Valve Springs only recommended Edelbrock Sure Seat Valve Springs #5767. #5767. Use stock ratio (1.73:1) rocker arms only. Use stock ratio (1.73:1) rocker arms