Edelbrock Performer RPM 351-W Ford V8 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMER RPM
Camshaft/Lifters/Lube Kit
CATALOG #7182
MODEL: 351-W Ford V8
• PLEASE study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not hesitate to call our
Technical Hotline at: 1-800-416-8628.
• CAMSHAFT: Edelbrock Performer RPM camshafts are ground • IMPORTANT: This instruction sheet provides general installation
specifically for use with the corresponding Performer RPM manifold. guidelines which can affect your warranty. Rea

ملخص المحتوى في الصفحة رقم 2

NOTE: The front cover oil seal should be replaced before the front 1. This camshaft is designed to function with Edelbrock Sure Seat valve cover is re-installed. springs #5722. Do not use dual valve springs with this camshaft. Valve 13. Rotate engine until timing marks are aligned as shown in Figure 1. Spring Retainers #9733 may be used if your heads are equipped with 14. Remove cam sprocket bolt,washer, and fuel pump eccentric. Slide Chevrolet valves. Retainers #9724 will give 0.100" taller ins

ملخص المحتوى في الصفحة رقم 3

lobes next to them and also the cam bearing journals. If the engine is weights combined and should be at full advance at 3000-3500 rpm. run after this happens, the bottom of the lifters and the sides of the After timing is adjusted, re-connect the vacuum advance line. lobes will become clipped. NOTE: The best combination for any particular vehicle or application When installing a camshaft, it is always important to check for proper must be determined by trial and error using the above informati

ملخص المحتوى في الصفحة رقم 4

CAMSHAFT: Performer RPM Hydraulic CAMSHAFT: Performer RPM Hydraulic CATALOG: #7182 CATALOG: #7182 ENGINE: Ford 351-W V8 ENGINE: Ford 351-W V8 RPM RANGE: 1500-6500 RPM RANGE: 1500-6500 CAUTION: Do not use dual valve springs. CAUTION: Do not use dual valve springs. Use only recommended Edelbrock Sure Seat Use only recommended Edelbrock Sure Seat Valve Springs #5722. Valve Springs #5722. Use stock ratio (1.6:1) rocker arms only. Use stock ratio (1.6:1) rocker arms only. Duration at .004" Lift: Int