Edelbrock 7122 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMER RPM
Camshaft/Lifters/Lube Kit
CATALOG #7122
MODEL: 289-302 c.i.d. Ford V8 (not for
Boss 302 or 1985 & later roller lifter engines)
• PLEASE study these instructions carefully before installing
TO AVOID THESE PROBLEMS YOU MUST DO THE
your new camshaft. If you have any questions or problems, do
FOLLOWING:
not hesitate to call our Technical Hotline at: 1-800-416-8628.
Carefully study and understand all instructions.
Examine the camshaft for possible shipping damage (if
• CAMSHAFT: Edelbr

ملخص المحتوى في الصفحة رقم 2

8. Remove carburetor and intake manifold. Remove fuel pump. • VALVE SPRINGS 9. Remove rocker arms and pushrods. CAUTION: WARNINGS ABOUT YOUR WARRANTY CAUTION: If your engine has non-adjustable rocker arms In order for this Performer RPM cam and lifter kit to be covered (1969-1/2 or later), you must install screw-in studs and high per- under ANY WARRANTY you MUST use the correct Edelbrock formance adjustable rocker arms. Crane and other manufacturers Sure Seat Valve Springs. Failure to install ne

ملخص المحتوى في الصفحة رقم 3

• CAMSHAFT/LIFTER RUN-IN tions. The following procedure is only a guideline and in many cases, the manufacturing specifications for recommended carbu- CAUTION: Change the engine oil and filter before start-up and retors or timing may be best. again after the initial break-in. Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Vary engine speed • IGNITION TIMING between 2000 and 3000 rpm. Slow idle speeds may result in Ignition timing for this package may vary with each applic

ملخص المحتوى في الصفحة رقم 4

CAMSHAFT: Performer RPM Hydraulic CAMSHAFT: Performer RPM Hydraulic CATALOG #7122 CATALOG #7122 ENGINE: Ford 289-302 c.i.d. V8 ENGINE: Ford 289-302 c.i.d. V8 RPM RANGE: 1500-6500 RPM RANGE: 1500-6500 CAUTION: Do not use dual valve springs. Use only CAUTION: Do not use dual valve springs. Use only recommended Edelbrock Sure Seat Valve Springs #5722. recommended Edelbrock Sure Seat Valve Springs #5722. Use stock ratio (1.6:1) rocker arms only. Use stock ratio (1.6:1) rocker arms only. Durat