Edelbrock 5056 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TORKER II INTAKE MANIFOLD
For 1965-1979 326-455 c.i.d. Pontiac V8
(Not for Ram-Air V Cylinder Heads)
Catalog #5056
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools
and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing
this installation, it is recommended to have the installation completed by a mechanic

ملخص المحتوى في الصفحة رقم 2

• WARNING: In some installations, the metal valley cover below the intake manifold may have been over-tightened which can cause the upper edge of the cover to protrude out from the lower position of head. This results in an interference with the intake manifold. If this condition occurs, the manifold will not seat properly against head surface and a misalignment of bolts to the head will occur. If this is the case, tap metal valley cover down with a hammer to give clearance to manifold. This