Edelbrock 2162 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMER-PLUS CAMSHAFT / LIFTERS / LUBE KIT
CATALOG # 2162
MODEL: 396-454 c.i.d. Chevrolet V8 (1967 & later)
GENERAL INSTRUCTIONS
• Please study these instructions carefully before you remove your stock camshaft. If you have any questions or problems, do not hesitate to contact
our Technical Hotline at: 1-800-416-8628.
� These instructions are designed to give general installation guidelines. A complete step-by-step procedure manual would require many pages. If
you are a novice or just learnin

ملخص المحتوى في الصفحة رقم 2

15. Rotate engine until timing marks are aligned as in Figure 1. NOTE: On computer-controlled engines, adjusting the lifter pre-load any 16. Remove bolts retaining camshaft sprocket. Remove sprocket and looser than specified may cause valve clatter which will activate the chain. knock detector and result in retarded ignition timing. 17. Remove crank sprocket using a gear puller. 4. Install front timing cover with new gasket. 18. Remove camshaft. NOTE: Install new seal between oil pan and front c

ملخص المحتوى في الصفحة رقم 3

CAM GEARS AND CAMSHAFT END PLAY— If cam gear becomes loose, the cam will slide back in the block, causing the lifters to hit the lobes next to them and also the cam bearing journals. If the engine is run after this happens, the bottom of the lifters and the sides of the lobes will become chipped. TUBULAR EXHAUST SYSTEM—For best performance, a tubular exhaust system is recommended with the Performer package to provide the most low-end torque. Please consult your Edelbrock dealer or the Edelbrock