Edelbrock 2103 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PERFORMER-PLUS
CAMSHAFT / LIFTERS / LUBE KIT
CATALOG # 2103
MODEL: 400 c.i.d. Chevrolet V8 engines
GENERAL INSTRUCTIONS
• Please study these instructions carefully before you remove your stock camshaft. If you have any questions or problems, do not hesitate to contact
our Technical Hotline at: 1-800-416-8628.
� These instructions are designed to give general installation guidelines. A complete step-by-step procedure manual would require many pages. If you
are a novice or just learning to work

ملخص المحتوى في الصفحة رقم 2

15. Remove fuel pump and fuel pump pushrod. Rotate engine until timing � VALVE ADJUSTMENT marks are aligned as in Figure 1. 1. Turn the engine over until the No. 1 cylinder exhaust lifter starts to 16.Remove bolts retaining camshaft sprocket. Remove sprocket and move up. At this point install adjusting nut on intake rocker arm and chain. adjust to zero clearance between rocker arm and valve. From this point 17. Remove crank sprocket using a gear puller. turn adjusting nut down (clockwise) 1/2 tu

ملخص المحتوى في الصفحة رقم 3

CAM GEARS AND CAMSHAFT END PLAY— If cam gear becomes loose, the TUBULAR EXHAUST SYSTEM—For best performance, a tubular exhaust cam will slide back in the block, causing the lifters to hit the lobes next to system is recommended with the Performer package to provide the most them and also the cam bearing journals. If the engine is run after this hap- low-end torque. Please consult your Edelbrock dealer or the Edelbrock pens, the bottom of the lifters and the sides of the lobes will become catalog

ملخص المحتوى في الصفحة رقم 4

CAMSHAFT: Performer-Plus CAMSHAFT: Performer-Plus CATALOG #2103 CATALOG #2103 ENGINE: 400 c.i.d. Chevrolet V8, 1970 & later ENGINE: 400 c.i.d. Chevrolet V8, 1970 & later RPM RANGE: idle-5500 RPM RANGE: idle-5500 CAUTION: CAUTION: Use only Sure Seat Valve Springs, #5802 or 5902 Use only Sure Seat Valve Springs, #5802 or 5902 Use stock ratio rocker arms only Use stock ratio rocker arms only Duration at 0.006" Lift: Intake 288° Exhaust 288° Duration at 0.006" Lift: Intake 288° Exhaust 288° Duration