Edelbrock 16211-MBN-640 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTRUCTION SUPPLEMENT FOR 2000-
LATER HONDA XR650R



SPECIAL NOTE!!!!!!
The Edelbrock carb you have
purchased was designed to be used
with the Honda Power-Up manifold.
Honda part #16211-MBN-640.


Removing stock carburetor and cables.
9. Remove rag from manifold.

10. Install carburetor into manifold. Do not

tighten yet.

11. Install the pull cable (long shoulder on cable)
1. Remove seat and gas tank. Make sure fuel
into the 4:00 position and the re

ملخص المحتوى في الصفحة رقم 2

17. Install fuel tank and connect fuel line to petcock and secure with provided pinch clamp. Refer to figure 1. Do not bolt tank in place, as minor adjustments may be necessary. 18. Turn fuel petcock to “on” and check for leaks. 19. Open throttle 3-5 times to prime accelerator pump. Do not open throttle any more than 5 times as this may flood engine!! 20. Once pump is primed, get motor to TDC and kick through without opening throttle. If Motor will not fire with a few kicks, o