Subaru H7110FS300 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

REMOTE KEYLESS
ENTRY SYSTEM
INSTALLATION
FORESTER
INSTRUCTIONS
P/N: H7110FS300
Kit Contents:
1 Keyless Entry Control Module w/Integral Bracket
2 Remote Control Transmitters
1 Installation Manual
Tools Required:
#1 Flat-tip Screwdriver
#2 Phillips Head Screwdriver (short)
1
/4” Drive Ratchet
1
4-inch /4” Drive Extension
1
/4” Swivel
10 mm Socket
This device complies with FCC rules part 15. Operation is
subject to the following two conditions: (1) this device may
not cause harmful interference an

ملخص المحتوى في الصفحة رقم 2

A. Pre-Installation Notes 1. Vehicle Preparation a. Lower the driver’s side window to avoid inadvertently locking the keys in the vehicle during installation. b. Note and record station presets on radio for step #2 in section E. Finish the Installation. c. Disconnect negative battery terminal to prevent accidental shorting of any power circuits. 2. System Preparation Remove the keyless module and transmitters from the package and inspect for any physical dam- age. B. Installation 1. Remove one p

ملخص المحتوى في الصفحة رقم 3

3. Remove two M6 nuts, indicated by arrow in Figure 3, securing both the door lock timer module. Retain nuts for installation of keyless entry module. Disconnect the door lock timer harness from the module and discard the module. Disconnect 6-pin to 16-pin extension harness from the 16-pin (white housing) connector. Discard the extension harness. Figure 3 4. Insert the 16-pin (white housing) connector into the key- less entry module. 5. Install the keyless entry module to the location previ- ou

ملخص المحتوى في الصفحة رقم 4

C. System Test 1. Reconnect the negative battery terminal. 2. Close all vehicle doors (with dome light switch set to “Doors”). 3. Depress the LOCK/ARM button on the remote and the following should be observed: 3.1 All vehicle doors will lock 3.2 The vehicle courtesy (dome) light will turn off 3.3 The horn will chirp once. 4. Depress the UNLOCK/DISARM button on the remote and the following should be observed: 4.1 The driver’s door will unlock 4.2 The vehicle courtesy (dome) light will turn on (fo

ملخص المحتوى في الصفحة رقم 5

E. Finish the Installation 1. Replace the lower dash panel below the steering column previously removed in section B. 2. Reset presets on radio as noted in step 1. b. in section A. Pre-Installation Notes. Installation is now complete. 5