ملخص المحتوى في الصفحة رقم 1
Register your product and get support at
www.philips.com/welcome
55PFL7 705D
46PFL7 705D
40PFL7 705D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right
ملخص المحتوى في الصفحة رقم 2
Contents 8 Update your TV software 31 1 Notice 4 Checking your current software version 31 Preparing for the software update by USB 31 2 Important 5 Updating software 31 Product information 5 Screen care 5 Environmental care 5 9 Connect devices 33 Regulatory notices 5 Connection overview 33 Selecting your connection quality 34 Connecting your devices 35 3 Your TV 6 Add devices 37 Side controls and indicators 6 Remove devices 37 Remote control 6 10 Troubleshooting 38 4 Get started 8 Downloading a
ملخص المحتوى في الصفحة رقم 3
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of Purchase *Product Safety *Additional Benefits Notification Returning the enclosed card guarantees By registering your
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6
ملخص المحتوى في الصفحة رقم 5
Canadian notice 1 Notice Standard Television Receiving Apparatus, Canada BETS-7 / NTMR-7. This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. 2010 © Koninklijke Philips Electronics N.V. All rights reserved. Copyright Specifi cations are subject to change without notice. Trademarks are All other registered and unregistered trademarks are the property of the property of Koninklijke Philips Electronics N.V. or their respective their
ملخص المحتوى في الصفحة رقم 6
Environmental care 2 Impor tant Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure : • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to The packaging of this product is intended to be recycled. Contact your
ملخص المحتوى في الصفحة رقم 7
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome s b r c Side contr ols and indicators d q e e p f d g h c a o i b j a Standby indicator / remote control sensor n . b POWER Switches the TV on or off. The TV is not powered off completely unless it is physically unplugged. m c CHANNEL + / − Switches to the next or previous channel. l k d SOURCE Selects
ملخص المحتوى في الصفحة رقم 8
. r AUTO MODE a (Standby-On) Cycles through the preset picture and sound setting Switches the TV on or off. The TV is not powered off completely (see ‘Using auto mode’ on page 20). unless it is physically unplugged. b FAV s OPTIONS Displays a list of all channels marked as favorite. Press to access the most usab le items extracted from the main (Includes subchannels) menu. c SLEEP Sets a delay after which the TV switches to standby. d Color buttons (red / green / yellow / blue) Selects ta
ملخص المحتوى في الصفحة رقم 9
In addition to reading and understanding the safety instructions, 4 Get started consider the following before positioning your TV : • Ensure that you always have easy access to the AC power cord or plug to disconnect the TV from the power. • If the TV is mounted on a swivel base, ensure that no strain is Supplied accessories placed on the AC power cord when the TV is swiveled. Strain on the AC power cord can loosen connections. • Remote control • The ideal viewing distance for watching TV
ملخص المحتوى في الصفحة رقم 10
If you connect a set-top box through RF IN / OUT Connecting the antenna or cable If the TV is connected to a cable box or satellite set-top box via a coaxial connection, set the TV to channel 3 or 4, or to the channel specifi ed by the service provider. Cable If you connect to an antenna Any DTV programs that are broadcast in your area can be received for If you connect a set-top box through HDMI free through an antenna connection. If the TV is connected to a cable box or satellite set-top b
ملخص المحتوى في الصفحة رقم 11
Managing cables Connecting the AC power cord Route your antenna cable and all other cables through the cable holder Warning at the back of the TV. The holder helps keep your cables tidy and easily manageable. • Verify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable holder as illustrated below. 1 Locate the power connector at the back of the TV. The location of the power co
ملخص المحتوى في الصفحة رقم 12
Select [ Picture A] or [ Picture B] by pressing Í or Æ that is the most Switching on and set up the TV pleasing to you, then press OK. You see 5 different pictures to be completed. Before you switch on the TV, check that the AC power cord is properly . connected. Press POWER at the right side of the TV, or press Which side of the picture do you prefer? .( ) Standby-On on the remote control. The TV normally takes 25-30 Cancel P Picture A icture A Picture B seconds to start up and the fol
ملخص المحتوى في الصفحة رقم 13
Switching channels 5 Use your TV This section helps you perform basic TV operations. Switching your TV on or to standby Press CHANNEL + / − on the side of the TV. For digital channels, press a number (1 to 999) followed by a dot “ ” and then the corresponding • sub channel number (1 to 999). e.g. 108.30. To switch on • Press CH + / − or enter a number on the remote control. • Press . POWER at the side of the TV or press . (Standby-On) • Press PREV. CH to return to the previously viewed c
ملخص المحتوى في الصفحة رقم 14
Adjusting v olume Watching channels from a set-top box To watch channels from a set-top box 1 Switch on the set-top box. » The picture from your set-top box might appear automatically on the TV screen. 2 Use the remote control of your set-top box to select channels. If the picture does not appear 1 Press SOURCE repeatedly to select the set-top box and wait a few seconds for the picture to appear. 2 Use the remote control of your set-top box to select channels. Watching connected devices
ملخص المحتوى في الصفحة رقم 15
Lock or unlock your device from the home menu 6 Use more of your TV This section describes how to lock or unlock specifi ed device. 1 Press MENU on the remote control. Î ï Í Æ 2 Use / / / to select a device to lock or unlock. 3 Press OPTIONS on the remote control. Access TV menus 4 Use Î or ï to select [ Device lock] or [ Device unlock], then press OK. • If device lock is unlocked, [ Device lock] will be displayed. Menus help you to install channels, change picture and sound settings If d
ملخص المحتوى في الصفحة رقم 16
Watching streaming movies Net fl ix operations After you set up the connection to Netfl ix, you can browse the Instant With this unit, you can watch movies and TV episodes streamed instantly Queue and watch movies on your TV. from Netfl ix via the Internet. In order to use this feature, you must visit 1 Press NET TV on the remote control and then use Î / ï / Í / Æ to the following website on your PC and become a Netfl ix member. select [NETFLIX]. www.netfl ix.com/Philips • The Instant Queue will
ملخص المحتوى في الصفحة رقم 17
Enjoying internet radio with vTuner 3 In the station / folder list, use Î / ï to select the desired station, then press OK. • After loading, playback of the selected station will start. With this unit, you can enjoy Internet radio with vTuner via the Internet. • If you select a folder, use Î / ï to select the desired station in In order to listen to Internet radio, you must connect this unit to the the next hierarchy, then press OK. Internet. • To stop playback , press C. For the network conn
ملخص المحتوى في الصفحة رقم 18
Guide to the playback screen Remove from favorite list e.g.) Location 1 Follow steps 1 to 2 in ‘Internet radio playback’ on page 16. 11 1 2 Use Î / ï to select [Favorites], then press OK. 3 Use Î / ï to select the station you want to remove from vTuner |...| Sunhall [Favorites], then press Color buttons (green). All Stations 45 • Confi rmation message will appear. .. Tset1 4 Use Í / Æ to select [Yes], then press OK. 2 Tset2 10 •The selected station is removed from [Favorites] folder. Japan Weath
ملخص المحتوى في الصفحة رقم 19
Changing picture and sound settings Setting items Description Off Sets Color enhancement to off. Color [ ] [ ] You must set Home in Location (refer to page 26). enhancement On Makes colors more vivid bright colors. Otherwise, the settings you adjusted will not be memorized after you Off Sets Active control to off. turn off the unit. On with Adjusts backlight for the best picture quality by Light dynamically adjusting the backlight intensity in Active control Sensor accordance with lightin
ملخص المحتوى في الصفحة رقم 20
For 4:3 (480i, 480p) video signal Changing picture format 1 Press FORMAT on the remote control. [ ] [ ] Automatic Super zoom 2 Use Î or ï to select a picture format and press OK to confi rm your choice. [Wide screen] [4:3] Summar y of picture formats Display modes can be selected when the broadcasting station is sending 16:9 or 4:3 video signal. And 3 types of display modes can be selected for PC input signal. For 16:9 (480i, 480p, 720p) video signal / 4:3 (720p) video signal [ ] [ ] Movie e
