ملخص المحتوى في الصفحة رقم 1
Register your product and get support at
www.philips.com/support
55PFL4706
46PFL4706
40PFL4706
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User Manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right side
ملخص المحتوى في الصفحة رقم 2
Contents 7 Install channels 34 1 Notice 4 Selecting your menu language 34 Autoprogram 34 2 Important 5 Weak channel installation 34 Product information 5 Installation mode 34 Screen care 5 Uninstall channels 34 Environmental care 5 Return your settings to default values 34 Regulatory notices 5 8 Update your TV software 35 3 Your TV 6 Checking your current software version 35 Side controls and indicators 6 Preparing for the software update by USB 35 Remote control 6 Updating software 35 4 Get sta
ملخص المحتوى في الصفحة رقم 3
Return your Product Registration Card or register online at www.philips.com/support today to get the very most from your purchase. Registering your model with Philips makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/support to ensure: *Product Safety Notification *Additional Benefits By registering your product, you'll receive notification Registering your prod
ملخص المحتوى في الصفحة رقم 4
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6
ملخص المحتوى في الصفحة رقم 5
FCC Caution: Any changes or modifi cations not expressly 1 Notice approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Specifi cations are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. Country Code Statement P&F USA reserves the right to change prod
ملخص المحتوى في الصفحة رقم 6
Screen care TM VUDU is a trademark of VUDU, Inc. • Avoid stationary images as much as possible. Stationary images are images that remain on-screen for extended periods of time. ® CloudTV™ (CloudTV™ by ActiveVideo ) Examples include : on-screen menus, black bars and time displays. technology provided under license from If you must use stationary images, reduce screen contrast and ActiveVideo Networks, Inc. U.S. and Foreign brightness to avoid screen damage. Patents apply. CloudTV™ and t
ملخص المحتوى في الصفحة رقم 7
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/support r b q c Side contr ols and indicators d f e p f e g d h ab c o i a Ambient light sensor Adjusts backlight for the best picture quality by dynamically j adjusting the backlight intensity in accordance with lighting condition in the room when [Active control] is set to n [On with Light Sensor]. Please
ملخص المحتوى في الصفحة رقم 8
.( ) p MENU / EXIT a standby-On Toggles the home menu on or off. Switches the TV on or puts it in standby mode. The TV is not powered off completely unless it is physically unplugged. q AUTO MODE b FAV Cycles through preset picture and sound settings. Displays a list of all channels marked as favorite. (See ‘Using auto mode’ on page 23.) (Includes subchannels) r OPTIONS Displays a list of menu items applicable to the highlighted object or c SLEEP screen. Sets a delay after which the TV swi
ملخص المحتوى في الصفحة رقم 9
Positioning the TV 4 Get started W arning • Do not insert the AC power cord into the power socket outlet before all the connections are made. Supplied accessories • Lar ge screen TVs are heavy. 2 people are required to carry and handle a large screen TV. • Bef ore you move the TV, disconnect attached cables to prevent damage to connectors. • Remote Control • 2 x AAA, 1.5V Batteries • AC Power cord • Cable management tie In addition to reading and understanding safety instructions, consider
ملخص المحتوى في الصفحة رقم 10
If you connect a set-top box through RF IN / OUT Connecting the antenna or cable If the TV is connected to a cable box or satellite set-top box via a coaxial connection, set the TV to channel 3 or 4, or to the channel specifi ed by the service provider. c cable able a antenna ntenna antenna antenna RF cable RF cable OUT IIN IN N set-top bo set-top box x IN IIN N OUT RF cable RF cable IN If you connect to an antenna Any DTV programs that are broadcast in your area can be received for If you c
ملخص المحتوى في الصفحة رقم 11
Managing cables Connecting the AC power cord Route your antenna cable and all other cables through the cable management tie at the back of the TV. The holder helps keep your W arning cables tidy and easily manageable. • Verify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable management tie as illustrated below. 1 Locate the power connector at the back of the TV. The location of
ملخص المحتوى في الصفحة رقم 12
[ ] You must set Home . Otherwise, personalized picture and sound Switching on and initial setup settings will not be memorized after the unit goes to standby mode. • Select [Retail store], the unit will be set up with predefi ned setting Before you switch on the TV, check that the AC power cord is properly for retail displays. In this setting, the power consumption may connected. Press . POWER at the right side of the TV, or press ® possibly exceed the limited requirement of the ENERGY ST
ملخص المحتوى في الصفحة رقم 13
Switching channels 5 Use your TV This section helps you perform basic TV operations. S witching on your TV and putting it in standby mode Press CHANNEL + / − on the side of the TV. • Press CH + / − or enter a number on the remote control. For digital channels, press a number (1 to 999) followed by a dot “•” and then the corresponding sub channel number (1 to 999). e.g. 108.30. • Press PREV. CH to return to the previously viewed channel. To switch on • Press . POWER at the side of the
ملخص المحتوى في الصفحة رقم 14
Adjusting v olume 1 Press SOURCE repeatedly to select the set-top box and wait a few seconds for the picture to appear. 2 Use the remote control of your set-top box to select channels. Watching connected devices To watch connected devices 1 Switch on the connected device. » The picture from your connected device might appear automatically on the TV screen. 2 Use the remote control of the device to select channels. If the picture does not appear 1 Press SOURCE repeatedly to select the connecte
ملخص المحتوى في الصفحة رقم 15
Lock or unlock your device from the home menu 6 Use more of your TV This section describes how to lock or unlock specifi ed device. 1 Press MENU on the remote control. 2 Use Î/ï/Í /Æ to select a device to lock or unlock. Access TV menus 3 Press OPTIONS on the remote control. 4 Use Î/ï to select [ Device lock] or [ Device unlock], then press OK. Menus help you to install channels, change picture and sound settings • If device lock is unlocked, [ Device lock] will be displayed. then access othe
ملخص المحتوى في الصفحة رقم 16
Philips Wireless MediaConnect View photos, play music and watch videos using DLNA You can enjoy your TV as a PC monitor wirelessly using your home network. Make sure you download the Philips Wireless MediaConnect On your TV you can play video, music and photo fi les stored on DLNA software and install it on your PC before you perform the steps below. certifi ed home media servers connected to your home network. In order to use this feature, you must connect this unit to the Internet. Install
ملخص المحتوى في الصفحة رقم 17
Guide to DLNA Listen to music using DLNA 2 3 1 Press Î/ï to select a fi le or a folder. 2 Press OK or ÆΔ to play the selected fi les. Server 1 Audio • Press OK or ÆΔ to pause, press OK or ÆΔ again to resume. Server 2 Photos • Press ∫ to skip up the next fi le. 4 Server 3 Video • Press ¢ to skip down the previous fi le. Ê 1 Folder • Press to stop playback. • Press OPTIONS to display the optional menu, then use Î/ï Highway Blues Hig Hig g g ghwa hwayB y y y B y lue lues s Title: ... to select the d
ملخص المحتوى في الصفحة رقم 18
Net TV Enjoying internet radio with vTuner Net TV offers Internet services for your TV. Use the TV remote control With this unit, you can enjoy internet radio with vTuner via the internet.In to browse the Net TV Internet pages. You can play movies, listen to order to listen to internet radio, you must connect this unit to the internet. music and much more, all from your TV screen. - Because Net TV is an online system, it can be modifi ed over time to Internet radio pla yback better serve its p
ملخص المحتوى في الصفحة رقم 19
Guide to the pla yback screen Add stations on the vTuner website ) e.g. Location You can add stations which are not in the vTuner station list. 1 1 Follow steps 1 to 2 in ‘Internet radio playback’ on page 17. 2 Use Î/ï to select [Get access code], then press OK. • The latest vTuner website address and access code for this Jazz(3) unit will be displayed. Please take a note of the access code. FM 76.2 FM (This access code will be required when creating a vTuner Jazz jAzz jaZz jazZ 6 accoun
ملخص المحتوى في الصفحة رقم 20
Creating a New Station Using Twitter By entering your favorite artists or songs, Pandora selects music and You can view your Twitter feeds and more using the Twitter application creates a new station for you on the basis of the entered information. on this unit. 1 On the player screen, press Color buttons (blue) to display station - For more details about Twitter, please visit www.twitter.com list. 2 Press Color buttons ( yellow ) to call up the [Tool Menu]. Logging in to Twitter Î ï [ ] 3 U
